I.S. EN 1917:2002&AC:2008
Current
The latest, up-to-date edition.
Concrete manholes and inspection chambers, unreinforced, steel fibre and reinforced
Hardcopy , PDF
English
08-08-2010
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 General requirements
5 Special requirements
6 Test methods for finished products
7 Conformity evaluation
8 Marking
Annex A (normative) Test method for crushing strength of chamber and shaft units
Annex B (normative) Test methods for vertical strength of reducing units and capping units
Annex C (normative) Test methods for watertightness
Annex D (normative) Test method for water absorption
Annex E (normative) Test methods for installed steps
Annex F (normative) Manufacturer's quality assurance system
Annex G (normative) Sampling procedures for inspection of finished products
Annex H (normative) Sampling procedures for continuous inspection of crushing strength, vertical strength and watertightness (vertical unit hydrostatic)
Annex I (normative) Tasks for a product certification body
Annex J (normative) Procedure for unreinforced concrete chamber and shaft units where routine (continuous) inspection of crushing strength is primarily to minimum crushing load
Annex ZA (informative) Clauses of this European Standard addressing essential requirements or other provisions of EU Directives
Bibliography
This European Standard specifies performance requirements as defined in Table 1 and describes test methods for precast concrete units for inspection chambers designed to be used for inverts not exceeding 2 metres deep and manholes, of circular, rectangular (with or without chamfered or rounded corners) or elliptical internal shape, unreinforced, steel fibre and reinforced, with nominal sizes and normal length not exceeding DN 1 250 (circular) or LN 1 250 (rectangular or elliptical).
| Committee |
TC 165
|
| DocumentType |
Test Method
|
| Pages |
110
|
| ProductNote |
The date of any NSAI previous adoption may not match the date of its original CEN/CENELEC document. THIS STANDARD IS ALSO REFERES TO :EN 681-1,EN 1916
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Supersedes |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.