I.S. EN 2002-001:2006
Current
The latest, up-to-date edition.
AEROSPACE SERIES - METALLIC MATERIALS - TEST METHODS - PART 1: TENSILE TESTING AT AMBIENT TEMPERATURE
Hardcopy , PDF
English
01-01-2006
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Health and safety
5 Principle
6 Testing requirements
7 Test report
Annex A (normative) Types of test piece to be used for sheet
and strip with thickness less than or equal to 8 mm
Annex B (normative) Types of non-machined test piece to be
used in the case of bar, section and wire with a
diameter or thickness less than or equal to 8 mm
Annex C (normative) Types of machined test piece to be used in
the case of bar, section, plate and wire with diameter
or thickness greater than 8 mm and for forgings and
castings
Annex D (normative) Types of test piece to be used in the case
of tubes
Defines the requirements for the tensile testing of metallic materials at ambient temperature for aerospace applications.
| DocumentType |
Standard
|
| Pages |
24
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Standards | Relationship |
| EN 2002-001:2005 | Identical |
| PREN 4259 : 200P1 | AEROSPACE SERIES - METALLIC MATERIALS - DEFINITION OF GENERAL TERMS |
| EN 4258:1998 | Aerospace series - Metallic materials - General organization of standardization - Links between types of EN standards and their use |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.