I.S. EN 414:2000

Foreword
0 Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General principles
      4.1 All safety standards
      4.2 Type B standards
      4.3 Type C standards
      4.4 Need for a type B standard
      4.5 Deviation in a type c standard
5 Preliminary work for drafting
      5.1 General
      5.2 Determination of the necessity and/or priority
             for standardization
      5.3 Definition of the scope
      5.4 Identification of hazards, hazardous situations
             and hazardous events (see 6.7)
      5.5 Assessment of the risk(s) caused by hazard(s)
             (see EN 292-1:1991, clause 6 or EN 1050)
      5.6 Definition of the safety objectives and
             determination of the hazards, hazardous
             situations and events for which safety
             requirements and/or protective measures are
             needed (see EN 292-1:1991, table 2)
      5.7 Determination of safety requirements and/or
             protective measures to remove the hazard and/or
             limit the risk (see 6.8.2)
      5.8 Verification of compliance with the safety
             requirements and/or protective measures
             identified in 5.6 and 5.7 (see 6.9)
6 Format of a safety standard
      6.1 General
      6.2 Clause "Foreword"
      6.3 Clause "Introduction"
      6.4 Clause "Scope"
      6.5 Clause "Normative references"
      6.6 Clause "Terms and definitions, symbols and
             abbreviated terms"
      6.7 Clause "List of significant hazards"
      6.8 Clause "Safety requirements and/or protective
             measures"
      6.9 Clause "Verification of the safety requirements
             and/or protective measures"
      6.10 Clause "Information for use"
      6.11 Annexes
Annex A (normative) Procedure to be followed if type A or
                    type B standards are unavailable
Annex B (informative) General format of CEN/CENELEC standards
Annex C (informative) Model format of a type C European draft
                      standard
Bibliography

Specifies requirements for the drafting and presentation of European machinery standards, primarily to achieve consistency of the various standards to be prepared.