I.S. EN 438-2:2016&A1:2018
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
High-pressure decorative laminates (HPL) - Sheets based on thermosetting resins (usually called laminates) - Part 2: Determination of properties
Hardcopy , PDF
31-01-2020
English
15-01-2019
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Assessment of appearance
5 Determination of thickness
6 Determination of length and width
7 Determination of edge straightness
8 Determination of edge squareness
9 Determination of flatness
10 Resistance to surface wear
11 Resistance to abrasion (flooring grade laminates)
12 Resistance to immersion in boiling water
13 Substrate protection against water vapour
14 Resistance to water vapour
15 Resistance to wet conditions (Exterior grade laminates)
16 Resistance to dry heat
17 Dimensional stability at elevated temperature
18 Resistance to wet heat
19 Resistance to climatic shock (exterior grade laminates)
20 Resistance to impact by small-diameter ball
21 Resistance to impact by large diameter ball
22 Resistance to impact by large diameter ball (flooring grade laminates)
23 Resistance to cracking under stress (laminates ≤ 2 mm thick)
24 Resistance to crazing (Compact laminates)
25 Resistance to scratching
26 Resistance to staining
27 Light fastness (Xenon arc)
28 Resistance to UV light (Exterior grade laminates)
29 Resistance to artificial weathering (Exterior grade laminates)
30 Determination of the microscratch resistance
31 Formability (Method A)
32 Formability (Method B)
33 Resistance to blistering (Method A)
34 Resistance to blistering (Method B)
Annex A (informative) Surface finish and colour influence on surface evaluations
Annex B (informative) Calibration and maintenance of abrasion equipment
Annex C (normative) Measurement of shore A hardness
This document specifies the methods of test for determination of the properties of high-pressure decorative laminates as defined in Clause 3.
| Committee |
CEN/TC 249
|
| DocumentType |
Test Method
|
| Pages |
202
|
| ProductNote |
The date of any NSAIprevious adoption may not matchthe date of its original CEN/CENELEC document. THIS STANDARD ALSO REFERS TO :CIE 85:1989
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| EN 438-2:2016+A1:2018 | Identical |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.