I.S. EN 50083-5:2001
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 5: HEADEND EQUIPMENT
Hardcopy , PDF
English
01-01-2001
12-01-2010
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
1 Scope
1.1 General
1.2 Specific scope of this part 5
2 Normative references
3 Terms, definitions, symbols and abbreviations
3.1 Terms and definitions
3.2 Symbols
3.3 Abbreviation
4 Methods of measurement
4.1 Single-channel intermodulation
4.2 Three-carrier intermodulation measurement
4.3 Two carrier intermodulation measurement for
second and third order products
4.4 Carrier-to-spurious signal ratio at the output
4.5 Television carrier-to-noise ratio
4.6 Differential gain and phase for PAL/SECAM signals
4.7 Group delay variation
4.8 2T-pulse response, K-factor
4.9 Chrominance-luminance delay inequalities
(20T-pulse method)
4.10 Luminance non-linearity
4.11 Intermodulation distortion (FM stereo radio)
4.12 Decoding margin (Teletext)
4.13 Hum modulation of carrier
5 Performance requirements and recommendations
5.1 Safety
5.2 Electromagnetic compatability
5.3 Environmental
5.4 Marking
5.5 Mean time operation between failure (MTBF)
6 Signal requirements
6.1 Indoor units
6.2 Outdoor units
7 Data publication requirements
7.1 General
7.2 Indoor units - TV (AM and FM)
7.3 Indoor units - FM radio
7.4 Outdoor units
Annex A (normative) Definition of the specified test
frequency range for return loss and noise figure
Annex B (normative) Audio connector
Annex C (informative) Selectivity diagram for adjacent
channel transmission
Annex D (normative) Special national conditions
Annex E (informative) Measurement errors which occur due
to mismatched equipment
Specifies the characteristics of equipment used in the headends of terrestrial broadcast and satellite receiving systems.
| DocumentType |
Standard
|
| Pages |
56
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NBN EN 50083-5 : 2002 | Identical |
| DIN EN 50083-5 : 2001 | Identical |
| NEN EN 50083-5 : 2001 | Identical |
| EN 50083-5:2001 | Identical |
| NF EN 50083-5 : 2002 | Identical |
| BS EN 50083-5:2002 | Identical |
| UNE-EN 50083-5:2002 | Identical |
| HD 134.2 : 200S2 | RADIO-FREQUENCY CONNECTORS - COAXIAL UNMATCHED CONNECTOR |
| EN 60417-1:2002 | GRAPHICAL SYMBOLS FOR USE ON EQUIPMENT - PART 1: OVERVIEW AND APPLICATION |
| EN 50083-3:2002 | Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for coaxial cable networks |
| EN 50083-2:2012/A1:2015 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 2: ELECTROMAGNETIC COMPATIBILITY FOR EQUIPMENT |
| EN 60417-2:1999 | Graphical symbols for use on equipment - Part 2: Symbol originals |
| EN 60130-9:2011 | Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment |
| IEC 60169-8:1978 | Radio-frequency connectors. Part 8: R.F. coaxial connectors with inner diameter of outer conductor 6.5 mm (0.256 in) with bayonet lock - Characteristic impedance 50 ohms (Type BNC) |
| EN 50083-1:1993/A2:1997 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 1: SAFETY REQUIREMENTS |
| EN 60529:1991/AC:2016-12 | DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE) (IEC 60529 EDITION 2.2 CORRIGENDUM 2:2015) |
| HD 571 : 200S1 | GENERAL PRINCIPLES FOR THE CREATION OF GRAPHICAL SYMBOLS FOR USE ON EQUIPMENT |
| EN 60244-5:1994 | Methods of measurement for radio transmitters - Part 5: Performance characteristics for television transmitters |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.