I.S. EN 60065:2014

National Foreword
FOREWORD
INTRODUCTION
1 General
2 Terms and definitions
3 General requirements
4 General test conditions
5 Marking and instructions
6 Hazardous radiations
7 Heating under normal operating conditions
8 Constructional requirements with regard to the
   protection against electric shock
9 Electric shock hazard under normal operating
   conditions
10 Insulation requirements
11 Fault conditions
12 Mechanical strength
13 CLEARANCES and CREEPAGE DISTANCES
14 Components
15 TERMINALS
16 External flexible cords
17 Electrical connections and mechanical fixings
18 Mechanical strength of picture tubes and protection
   against the effects of implosion
19 Stability and mechanical hazards
20 Resistance to fire
Annex A (normative) - Additional requirements for apparatus
        with protection against splashing water
Annex B (normative) - Apparatus to be connected to the
        TELECOMMUNICATION NETWORKS
Annex C (normative) - Band-pass filter for wide-band noise
        measurement
Annex D (normative) - Measuring network for TOUCH
        CURRENTS
Annex E (normative) - Measurement of CLEARANCES and
        CREEPAGE DISTANCES
Annex F (normative) - Table of electrochemical potentials
Annex G (normative) - Flammability test methods
Annex H (normative) - Insulated winding wires for use
        without interleaved insulation
Annex I (Void)
Annex J (normative) - Alternative method for determining
        minimum CLEARANCES
Annex K (normative) - Impulse test generators
Annex L (normative) - Additional requirements for electronic
        flash apparatus for photographic purposes
Annex M (informative) - Examples of requirements for quality
        control programmes for allowing reduced clearances
Annex N (informative) - Routine tests
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their corresponding
         European publications
Annex ZB (normative) - Special national conditions
Annex ZC (informative) - A-deviations
Annex ZD (informative) - IEC and CENELEC code
         designations for flexible cords
Annex ZE (informative) - Significance of L[Aeq],[T] in
         EN 50332-1 and additional information

Pertains to electronic apparatus designed to be fed from the MAINS, from a SUPPLY APPARATUS, from batteries or from REMOTE POWER FEEDING and intended for reception, generation, recording or reproduction of audio, video and associated signals.