• I.S. EN 60076-3:2013

    Current The latest, up-to-date edition.

    POWER TRANSFORMERS - PART 3: INSULATION LEVELS, DIELECTRIC TESTS AND EXTERNAL CLEARANCES IN AIR

    Available format(s):  Hardcopy, PDF

    Language(s):  English

    Published date:  01-01-2013

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    NATIONAL FOREWORD
    FOREWORD
    INTRODUCTION
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 General
    5 Highest voltage for equipment and rated insulation
       level
    6 Transformers with re-connectable windings
    7 Dielectric tests
    8 Dielectric tests on transformers that have been
       in service
    9 Insulation of auxiliary wiring (AuxW)
    10 Applied voltage test (AV)
    11 Induced voltage tests (IVW and IVPD)
    12 Line terminal AC withstand test (LTAC)
    13 Lightning impulse tests (LI, LIC, LIN, LIMT)
    14 Switching impulse test (SI)
    15 Action following test failure
    16 External clearances in air
    Annex A (informative) - Application guide for partial
            discharge measurements on transformers
    Annex B (informative) - Overvoltage transferred from
            the high-voltage winding to a low-voltage
            winding
    Annex C (informative) - Information on transformer
            insulation and dielectric tests to be supplied
            with an enquiry and with an order
    Annex D (informative) - Neutral insulation voltage level
            calculation
    Annex E (informative) - Basis for dielectric tests, insulation
            levels and clearances
    Bibliography
    Annex ZA (normative) - Normative references to international
             publications with their corresponding European
             publications

    Abstract - (Show below) - (Hide below)

    Pertains to power transformers and provides details of the applicable dielectric tests and minimum dielectric test levels.

    General Product Information - (Show below) - (Hide below)

    Development Note 2001 Edition Issued on 02/02/2006. Supersedes I.S. HD 398.3. (11/2009) For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Current

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 60060-2:2010 High-voltage test techniques - Part 2: Measuring systems
    IEC 60270:2000+AMD1:2015 CSV High-voltage test techniques - Partial discharge measurements
    EN 60060-1:2010 High-voltage test techniques - Part 1: General definitions and test requirements
    IEEE C57.12.00-2015 IEEE Standard for General Requirements for Liquid-Immersed Distribution, Power, and Regulating Transformers
    EN 60270:2001/A1:2016 HIGH-VOLTAGE TEST TECHNIQUES - PARTIAL DISCHARGE MEASUREMENTS (IEC 60270:2000/A1:2015)
    IEC 60076-4:1976 Power transformers - Part 4: Tappings and connections
    EN 60060-2:2011 High-voltage test techniques - Part 2: Measuring systems
    IEC 60050-421:1990 International Electrotechnical Vocabulary (IEV) - Part 421: Power transformers and reactors
    IEC 60076-1:2011 Power transformers - Part 1: General
    IEEE C57.142 : 2010 GUIDE TO DESCRIBE THE OCCURRENCE AND MITIGATION OF SWITCHING TRANSIENTS INDUCED BY TRANSFORMERS, SWITCHING DEVICE, AND SYSTEM INTERACTION
    EN 60071-1:2006/A1:2010 INSULATION CO-ORDINATION - PART 1: DEFINITIONS, PRINCIPLES AND RULES
    EN 60076-1:2011 POWER TRANSFORMERS - PART 1: GENERAL (IEC 60076-1:2011)
    IEC 62271-1:2017 High-voltage switchgear and controlgear - Part 1: Common specifications for alternating current switchgear and controlgear
    IEC 60071-2:1996 Insulation co-ordination - Part 2: Application guide
    IEC 61083-2:2013 Instruments and software used for measurement in high-voltage and high-current tests - Part 2: Requirements for software for tests with impulse voltages and currents
    IEC 60060-1:2010 High-voltage test techniques - Part 1: General definitions and test requirements
    IEC 60071-1:2006+AMD1:2010 CSV Insulation co-ordination - Part 1: Definitions, principles and rules
    IEC 61083-1:2001 Instruments and software used for measurement in high-voltage impulse tests - Part 1: Requirements for instruments
    IEC 60214-1:2014 Tap-changers - Part 1: Performance requirements and test methods
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective