Skip to content
Please enter a keyword to search
  • Preview

    I.S. EN 60507:2014

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    ARTIFICIAL POLLUTION TESTS ON HIGH-VOLTAGE CERAMIC AND GLASS INSULATORS TO BE USED ON A.C. SYSTEMS

    Available format(s):  Hardcopy, PDF

    Superseded date:  02-10-2018

    Language(s): 

    Published date:  01-04-2014

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 General test requirements
    5 Salt fog method
    6 Solid layer methods
    Annex A (informative) - Supplementary information on the
            assessment of the requirement for the testing plant
    Annex B (informative) - Determination of the withstand
            characteristics of insulators
    Annex C (informative) - Measurement of layer conductivity for
            checking the uniformity of the layer
    Annex D (informative) - Additional recommendations concerning
            the solid layer method procedures
    Annex E (informative) - Supplementary information on artificial
            pollution tests on insulators for voltage systems of
            800 kV and above (solid layer method procedure B)
    Bibliography
    Annex ZA (normative) - Normative references to
             international publications with their corresponding
             European publications

    Abstract - (Show below) - (Hide below)

    Pertains to the determination of the power frequency withstand characteristics of ceramic and glass insulators to be used outdoors and exposed to polluted atmospheres, on a.c. systems with the highest voltage of the system greater than 1000 V.

    General Product Information - (Show below) - (Hide below)

    Committee TC 36
    Development Note For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By
    Supersedes

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC TS 60815-2:2008 Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 2: Ceramic and glass insulators for a.c. systems
    EN 60060-1:2010 High-voltage test techniques - Part 1: General definitions and test requirements
    EN 60071-1:2006/A1:2010 INSULATION CO-ORDINATION - PART 1: DEFINITIONS, PRINCIPLES AND RULES
    IEC 60060-1:2010 High-voltage test techniques - Part 1: General definitions and test requirements
    IEC 60071-1:2006+AMD1:2010 CSV Insulation co-ordination - Part 1: Definitions, principles and rules
    IEC TS 60815-1:2008 Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 1: Definitions, information and general principles
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective