I.S. EN 60662:2012

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General lamp requirements
5 Marking
6 Dimensions
7 Caps
8 Test requirements for lamp starting, warm-up,
   electrical and photometric characteristics
9 Information for ballast and ignitor design
10 Information for luminaire design
11 Maximum lamp outlines
12 Numbering system for lamp data sheets
Annex A (normative) - Waveshape of voltage
        pulses for lamp starting test (schematic
        drawings)
Annex B (informative) - Diagrammatic data sheets
        for location of lamp dimensions
Annex C (normative) - Guidance for determining
        quadrilateral diagrams
Annex D (normative) - Measurement of voltage
        increase at lamp terminals for luminaire
        design
Annex E (informative) - HPS lamp drop-out voltage
        measurement procedure
Annex F (normative) - Fixed settings of the
        ignition device and requirements for
        ignition
Annex G (normative) - Method of measuring electrical
        and photometrical characteristics
Annex H (normative) - Method of test for lumen
        maintenance and life
Annex I (informative) - Maximum lamp outlines
Annex J (normative) - Lamp data sheets
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

Describes performance requirements for high-pressure Sodium vapour lamps for general lighting purposes which comply with the safety requirements of IEC 62035.