• I.S. EN 60835-3-5:1995

    Current The latest, up-to-date edition.

    METHODS OF MEASUREMENT FOR EQUIPMENT USED IN DIGITAL MICROWAVE RADIO TRANSMISSION SYSTEMS - PART 3: MEASUREMENTS ON SATELLITE EARTH STATIONS - SECTION 5: UP- AND DOWN-CONVERTERS

    Available format(s):  Hardcopy, PDF

    Language(s):  English

    Published date:  01-01-1995

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    1 Scope
    2 Normative references
    3 General
       3.1 Up-converter
       3.2 Down-converter
    4 Input and output return loss
    5 Input and output level or power
    6 Gain
       6.1 Gain stability
       6.2 Gain compression
    7 Automatic gain control (a.g.c.)
       7.1 Definition and general considerations
       7.2 Method of measurement
       7.3 Presentation of results
       7.4 Details to be specified
    8 Amplitude modulation/phase modulation conversion
        factor
    9 Amplitude/frequency characteristic
    10 Group delay/frequency characteristic
    11 Spurious output signals (including harmonics)
    12 Intermodulation products
    13 Phase noise
       13.1 Definition and general considerations
       13.2 Method of measurement using a spectrum analyser
       13.3 Alternative method of measurement for down-converters
       13.4 Alternative method of measurement for up-converters
       13.5 Presentation of results
       13.6 Details to be specified
    14 Noise figure
       14.1 Up-converter
       14.2 Down-converter
       14.3 Calibration
       14.4 Correction of the measurement data
       14.5 Presentation of results
       14.6 Details to be specified
    15 Local oscillator frequency
    Annex ZA (normative) Other international publications quoted
                         in this standard with the reference of the
                         relevant European publications

    Abstract - (Show below) - (Hide below)

    Defines methods of measurement of the electrical characteristics of up-converters and down-converters used in satellite earth station transmitters and receivers with digital modulation.

    General Product Information - (Show below) - (Hide below)

    Development Note For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Current

    Standards Referencing This Book - (Show below) - (Hide below)

    EN 60835-1-1:1992 Methods of measurement for equipment used in digital microwave radio transmission systems - Part 1: Measurements common to terrestrial radio-relay systems and satellite earth stations - Section 1: General
    IEC 60835-3-4:1993 Methods of measurement for equipment used in digital microwave radio transmission systems - Part 3: Measurements on satellite earth stations - Section 4: Low noise amplifier
    IEC 60835-1-1:1990 Methods of measurement for equipment used in digital microwave radio transmission systems. Part 1: Measurements common to terrestrial radio-relay systems and satellite earth stations - Section One: General
    EN 60835-1-2:1993/A1:1995 METHODS OF MEASUREMENT FOR EQUIPMENT USED IN DIGITAL MICROWAVE RADIO TRANSMISSION SYSTEMS - PART 1: MEASUREMENTS COMMON TO TERRESTRIAL RADIO-RELAY SYSTEMS AND SATELLITE EARTH STATIONS - SECTION 2: BASIC CHARACTERISTICS (IEC 835-1-2:1992/A1:1995)
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective