Skip to content
Please enter a keyword to search
  • Preview

    I.S. EN 61010-2-032:2012

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    SAFETY REQUIREMENTS FOR ELECTRICAL EQUIPMENT FOR MEASUREMENT, CONTROL, AND LABORATORY USE - PART 2-032: PARTICULAR REQUIREMENTS FOR HAND-HELD AND HAND-MANIPULATED CURRENT SENSORS FOR ELECTRICAL TEST AND MEASUREMENT (IEC 61010-2-032:2012 (EQV))

    Available format(s):  Hardcopy, PDF

    Superseded date:  08-12-2021

    Language(s):  English

    Published date:  01-01-2012

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    INTRODUCTION
    1 Scope and object
    2 Normative references
    3 Terms and definitions
    4 Tests
    5 Marking and documentation
    6 Protection against electric shock
    7 Protection against mechanical HAZARDS
    8 Resistance to mechanical stresses
    9 Protection against the spread of fire
    10 Equipment temperature limits and resistance
        to heat
    11 Protection against HAZARDS from fluids
    12 Protection against radiation, including laser
        sources, and against sonic and ultrasonic pressure
    13 Protection against liberated gases and substances,
        explosion and implosion
    14 Components and subassemblies
    15 Protection by interlocks
    16 HAZARDS resulting from application
    17 RISK assessment
    101 Measuring circuits
    102 Prevention of HAZARD from arc flash and
        short-circuits
    Annexes
    Annex D (normative) - Parts between which insulation
            requirements are specified
    Annex F (normative) - ROUTINE TESTS
    Annex K (normative) - Insulation requirements not
            covered by 6.7
    Annex L (informative) - Index of defined terms
    Annex AA (normative) - MEASUREMENT CATEGORIES
    Annex BB (informative) - HAZARDS pertaining to
             measurements performed in certain environments
    Bibliography

    Abstract - (Show below) - (Hide below)

    Describes safety requirements for HAND-HELD and hand-manipulated current sensors.

    General Product Information - (Show below) - (Hide below)

    Development Note For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By
    Supersedes

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 61010-2-033:2012 Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 2-033: Particular requirements for hand-held multimeters and other meters, for domestic and professional use, capable of measuring mains voltage
    EN 41003:2008 Particular safety requirements for equipment to be connected to telecommunication networks and/or a cable distribution system
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective