I.S. EN 61215-2:2017
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
TERRESTRIAL PHOTOVOLTAIC (PV) MODULES - DESIGN QUALIFICATION AND TYPE APPROVAL - PART 2: TEST PROCEDURES
Hardcopy , PDF
08-05-2021
English
01-01-2017
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
National Foreword
FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Terms and definitions
4 Test procedures
Annex ZA (normative) - Normative references to international
publications with their corresponding European publications
Describes for the design qualification and type approval of terrestrial photovoltaic modules suitable for long-term operation in general open-air climates, as defined in IEC 60721-2-1.
| DevelopmentNote |
Supersedes I.S. EN 61215. For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (03/2017) Supersedes I.S. EN 61646. (07/2017)
|
| DocumentType |
Standard
|
| Pages |
124
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| EN 61215-2:2017 | Identical |
| EN 61215-2 : 2017 COR 2018 | Identical |
| EN 60904-3:2016 | Photovoltaic devices - Part 3: Measurement principles for terrestrial photovoltaic (PV) solar devices with reference spectral irradiance data |
| EN 60904-2:2015 | Photovoltaic devices - Part 2: Requirements for photovoltaic reference devices |
| IEC 60904-1:2006 | Photovoltaic devices - Part 1: Measurement of photovoltaic current-voltage characteristics |
| CLC/TS 61836:2009 | Solar photovoltaic energy systems - Terms, definitions and symbols |
| EN 60904-9 : 2007 | PHOTOVOLTAIC DEVICES - PART 9: SOLAR SIMULATOR PERFORMANCE REQUIREMENTS |
| IEC 60904-10:2009 | Photovoltaic devices - Part 10: Methods of linearity measurement |
| IEC 60068-1:2013 | Environmental testing - Part 1: General and guidance |
| IEC 60904-9:2007 | Photovoltaic devices - Part 9: Solar simulator performance requirements |
| IEC TS 61836:2007 | Solar photovoltaic energy systems - Terms, definitions and symbols |
| IEC 60068-2-21:2006 | Environmental testing - Part 2-21: Tests - Test U: Robustness of terminations and integral mounting devices |
| EN 60068-1:2014 | Environmental testing - Part 1: General and guidance |
| EN 60904-8:2014 | Photovoltaic devices - Part 8: Measurement of spectral responsivity of a photovoltaic (PV) device |
| IEC 60904-8:2014 | Photovoltaic devices - Part 8: Measurement of spectral responsivity of a photovoltaic (PV) device |
| EN 60904-1:2006 | PHOTOVOLTAIC DEVICES - PART 1: MEASUREMENT OF PHOTOVOLTAIC CURRENT-VOLTAGE CHARACTERISTICS |
| IEC 60904-2:2015 RLV | Photovoltaic devices - Part 2: Requirements for photovoltaic reference devices |
| IEC 60721-2-1:2013 | Classification of environmental conditions - Part 2-1: Environmental conditions appearing in nature - Temperature and humidity |
| EN 60904-7:2009 | Photovoltaic devices - Part 7: Computation of the spectral mismatch correction for measurements of photovoltaic devices |
| IEC 60904-7:2008 | Photovoltaic devices - Part 7: Computation of the spectral mismatch correction for measurements of photovoltaic devices |
| EN 60068-2-21:2006 | Environmental testing - Part 2-21: Tests - Test U: Robustness of terminations and integral mounting devices |
| IEC 60904-3:2016 | Photovoltaic devices - Part 3: Measurement principles for terrestrial photovoltaic (PV) solar devices with reference spectral irradiance data |
| EN 60068-2-78:2013 | Environmental testing - Part 2-78: Tests - Test Cab: Damp heat, steady state |
| EN 60891:2010 | Photovoltaic devices - Procedures for temperature and irradiance corrections to measured I-V characteristics |
| EN ISO 868:2003 | Plastics and ebonite - Determination of indentation hardness by means of a durometer (Shore hardness) (ISO 868:2003) |
| EN 62790:2015 | Junction boxes for photovoltaic modules - Safety requirements and tests |
| EN 60904-10:2010 | Photovoltaic devices - Part 10: Methods of linearity measurement |
| IEC 60891:2009 | Photovoltaic devices - Procedures for temperature and irradiance corrections to measured I-V characteristics |
| EN 61215-1:2016 | Terrestrial photovoltaic (PV) modules - Design qualification and type approval - Part 1: Test requirements |
| EN 60721-2-1:2014 | Classification of environmental conditions - Part 2-1: Environmental conditions appearing in nature - Temperature and Humidity |
| ISO 868:2003 | Plastics and ebonite — Determination of indentation hardness by means of a durometer (Shore hardness) |
Important note : Users cannot be edited or removed once added to your Multi user PDF.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Logging out.