I.S. EN 61238-1:2003

FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Definitions
4 Symbols
5 General
  5.1 Conductor
  5.2 Connectors and tooling
  5.3 Range of approval
6 Electrical tests
  6.1 Installation
  6.2 Measurements
  6.3 Heat cycle test
  6.4 Assessment of results
  6.5 Requirements
7 Mechanical tests
  7.1 Method
  7.2 Requirements
8 Test report
Annex A (normative) Equalizers and their preparation
Annex B (normative) Measurements
Annex C (informative) Recommendations to improve accuracy
                      of measurement
Annex D (informative) Determination of the value of the
                      short-circuit-current
Annex E (normative) Calculation method
Annex F (informative) Explanation of the calculation method
Annex G (informative) Explanation of the temperature profile
Annex H (informative) Explanation of the statistical method
                      of assessing results of tests on
                      electrical connectors

Applies to compression and mechanical connectors for power cables for rated voltages up to 30 kV (U[m] = 36 kV), e.g. buried cables or cables installed in buildings, having a) conductors complying with IEC 60228 and IEC 60228A with cross-sectional areas 10 mm[2] and greater for copper and 16 mm[2] and greater for aluminium, b) a maximum continuous conductor temperature not exceeding 90 degree C.