• I.S. EN 61241-11:2007

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    ELECTRICAL APPARATUS FOR USE IN THE PRESENCE OF COMBUSTIBLE DUST - PART 11: PROTECTION BY INTRINSIC SAFETY "ID"

    Available format(s):  Hardcopy, PDF

    Superseded date:  24-01-2012

    Language(s):  English

    Published date:  01-01-2007

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    INTRODUCTION
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Grouping and classification of intrinsically safe apparatus
       and associated apparatus
    5 Categories of electrical apparatus
    6 Apparatus construction
       6.1 Enclosures
       6.2 Temperatures of apparatus immersed in dust
             6.2.1 General
             6.2.2 Apparatus and component temperature
             6.2.3 Standardized dust immersion temperature test
             6.2.4 Wiring within apparatus
             6.2.5 Printed circuit wiring
             6.2.6 Unenclosed circuits
       6.3 Facilities for connection of external circuits
             6.3.1 Terminals
             6.3.2 Plugs and sockets
             6.3.3 Determination of maximum external inductance
                    to resistance ratio (Lo/Ro) for resistance
                    limited power source
             6.3.4 Permanently connected cables
       6.4 Separation distances
       6.5 Protection against polarity reversal
       6.6 Earth conductors, connections and terminals
       6.7 Encapsulation used for exclusion of potentially
             explosive atmosphere
    7 Components on which intrinsic safety depends
       7.1 Rating of components
       7.2 Connectors for internal connections, plug-in cards
             and components
       7.3 Fuses
       7.4 Primary and secondary cells and batteries
       7.5 Semiconductors
       7.6 Failure of components and connections
       7.7 Piezo-electric devices
    8 Infallible components, infallible assemblies of components
       and infallible connections
    9 Diode safety barriers
    10 Type verifications, assessments and type tests
       10.1 Spark ignition assessment
       10.2 Temperature tests
       10.3 Voltage tests
       10.4 Small component ignition test
       10.5 Determination of parameters of loosely specified
             components
       10.6 Tests for cells and batteries
       10.7 Mechanical test
             10.7.1 Casting compound
             10.7.2 Partitions
       10.8 Tests for apparatus containing piezoelectric devices
       10.9 Type tests for diode safety barriers and safety shunts
       10.10 Cable pull test
    11 Routine verifications and tests
    12 Marking
       12.1 General
       12.2 Marking of connection facilities
    13 Documentation
    Annex A (normative) See Annex B of IEC 60079-11
    Annex B (informative) See Annex C of IEC 60079-11
    Annex C (normative) See Annex D of IEC 60079-11
    Annex ZA (normative) Normative references to international
             publications with their corresponding European
             publications
    Annex ZZ (informative) Coverage of Essential Requirements
             of EC Directives

    Abstract - (Show below) - (Hide below)

    Specifies requirements for the construction and testing of intrinsically safe apparatus intended for use in potentially explosive dust cloud or dust layer environments and for associated apparatus that is intended for connection to intrinsically safe circuits which enter such environments.

    General Product Information - (Show below) - (Hide below)

    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    EN 60079-0:2012/A11:2013 EXPLOSIVE ATMOSPHERES - PART 0: EQUIPMENT - GENERAL REQUIREMENTS (IEC 60079-0:2011, MODIFIED)
    IEC 61241-0:2004 Electrical apparatus for use in the presence of combustible dust - Part 0: General requirements
    EN 60079-11:2012 Explosive atmospheres - Part 11: Equipment protection by intrinsic safety "i"
    IEC 60079-11:2011 Explosive atmospheres - Part 11: Equipment protection by intrinsic safety "i"
    EN 61241-1:2004/corrigendum Dec. 2006 ELECTRICAL APPARATUS FOR USE IN THE PRESENCE OF COMBUSTIBLE DUST - PART 1: PROTECTION BY ENCLOSURES "TD"
    IEC 61241-1:2004 Electrical apparatus for use in the presence of combustible dust - Part 1: Protection by enclosures "tD"
    EN 60079-25:2010/AC:2013 EXPLOSIVE ATMOSPHERES - PART 25: INTRINSICALLY SAFE ELECTRICAL SYSTEMS (IEC 60079-25:2010)
    IEC 60529:1989+AMD1:1999+AMD2:2013 CSV Degrees of protection provided by enclosures (IP Code)
    IEC 60079-25:2010 Explosive atmospheres - Part 25: Intrinsically safe electrical systems
    IEC 60079-0:2011 Explosive atmospheres - Part 0: Equipment - General requirements
    EN 61241-0:2006 Electrical apparatus for use in the presence of combustible dust - Part 0: General requirements
    EN 60529:1991/AC:2016-12 DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE) (IEC 60529 EDITION 2.2 CORRIGENDUM 2:2015)
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective