I.S. EN 62282-3-201:2017

National Foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Configuration of small stationary fuel cell power system
6 Reference conditions
7 Heating value base
8 Test preparation
9 Test set-up
10 Instruments and measurement methods
11 Test conditions
12 Operating process
13 Test plan
14 Type tests on electric/thermal performance
15 Type tests on environmental performance
16 Test reports
Annex A (normative) - Heating values for components of
        natural gases
Annex B (informative) - Examples of composition for natural
        gases and propane gases
Annex C (informative) - Example of a test operation
        schedule
Annex D (informative) - Typical exhaust gas components
Annex E (informative) - Guidelines for the contents of
        detailed and full reports
Annex F (informative) - Selected duration of rated power
        operation
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

Describes test methods for the electrical, thermal and Environmental performance of small stationary fuel cell power systems that meet the following criteria: - output - rated electric power output of less than 10 kW; - output mode - grid-connected/independent operation or stand-alone operation with singlephase AC output or 3-phase AC output not exceeding 1000 V, or DC output not exceeding1500 V; - operating pressure - maximum allowable working pressure of less than 0,1 MPa (gauge) for the fuel and oxidant passages; - fuel - gaseous fuel (natural gas, liquefied petroleum gas, propane, butane, hydrogen, etc.) or liquid fuel (kerosene, methanol, etc.); - oxidant - air.