I.S. EN ISO 11812:2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SMALL CRAFT - WATERTIGHT COCKPITS AND QUICK-DRAINING COCKPITS
Hardcopy , PDF
07-02-2019
English
01-01-2002
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 General requirements
5.1 Loading and measurement conditions
5.2 Requirements for "watertight" cockpits and recesses
5.3 Requirements for "quick draining" cockpits and recesses
5.4 Closing appliances
6 Requirements for quick-draining cockpit bottom
6.1 Minimum cockpit bottom height, H[B,min]
6.2 Exception to 6.1 for recesses or lockers
6.2.1 Exception up to 10 % of cockpit bottom area
6.2.2 Lockers in the cockpit bottom
7 Requirements for drainage of quick-draining cockpits
7.1 Cockpit drainage
7.1.1 General
7.1.2 When the boat is upright
7.1.3 When the boat is heeled
7.2 Draining time
7.3 Number of drains
7.4 Minimum drain dimensions
7.4.1 Internal dimensions of the drain
7.4.2 Eventual protective grids
7.5 Centreboard housings and other types of drain
7.6 Drain fitting
7.7 Drain piping design and construction
7.8 Draining time assessment
7.8.1 General
7.8.2 Measurement of the draining time
7.8.3 Calculation of the draining time
7.8.4 Quick method of calculation for cockpit fitted
with two drains
8 Requirement for sills
8.1 Sill height for watertight cockpits
8.2 Sill height and other requirements for quick-draining
cockpits
8.2.1 Sill-height measurement
8.2.2 Requirements for sill height of quick draining
cockpits
8.2.3 Requirements for companionway doors and appliances
above sill height
8.2.4 Other requirements
9 Watertightness requirements
9.1 Watertightness requirements of watertight cockpits
9.2 Watertightness requirements of quick-draining cockpits
9.2.1 Watertightness of the cockpit
9.2.2 Permanently open ventilation openings
10 Owner's manual - Documentation
Annex A (informative) Examples of single-plane cockpit bottoms
Annex B (normative) Analysis of multi-level cockpit bottom
Annex C (normative) Draining time calculation using tables
Annex D (normative) Alternative method of calculation - Direct
calculation with head losses
Annex E (normative) Watertightness tests
Annex ZA (informative) Clauses of this European Standard
addressing essential requirements or other provisions
of EU Directives
Bibliography
Describes requirements for cockpits and recesses to be designated either as "watertight" or as "quick-draining" on small craft of hull length up to 24 m.
| DocumentType |
Standard
|
| Pages |
50
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| EN ISO 11812:2001 | Identical |
| UNE-EN ISO 11812:2002 | Identical |
| UNI EN ISO 11812 : 2003 | Identical |
| DIN EN ISO 11812:2003-07 | Identical |
| NBN EN ISO 11812 : 2002 | Identical |
| EN ISO 11812:2018 | Identical |
| BS EN ISO 11812:2002 | Identical |
| ONORM EN ISO 11812 : 2002 | Identical |
| NS EN ISO 11812 : 1ED 2002 | Identical |
| SN EN ISO 11812 : 2001 | Identical |
| NEN EN ISO 11812 : 2002 | Identical |
| NF EN ISO 11812 : 2003 | Identical |
| ISO 11812:2001 | Identical |
| ISO 12217-3:2015 | Small craft — Stability and buoyancy assessment and categorization — Part 3: Boats of hull length less than 6 m |
| ISO 12217-2:2015 | Small craft — Stability and buoyancy assessment and categorization — Part 2: Sailing boats of hull length greater than or equal to 6 m |
| ISO 8666:2016 | Small craft Principal data |
| ISO 12217-1:2015 | Small craft — Stability and buoyancy assessment and categorization — Part 1: Non-sailing boats of hull length greater than or equal to 6 m |
| ISO 9093-2:2002 | Small craft Seacocks and through-hull fittings Part 2: Non-metallic |
| ISO 12216:2002 | Small craft Windows, portlights, hatches, deadlights and doors Strength and watertightness requirements |
| ISO 9093-1:1994 | Small craft Seacocks and through-hull fittings Part 1: Metallic |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.