I.S. EN ISO 14744-1:2008
Current
The latest, up-to-date edition.
WELDING - ACCEPTANCE INSPECTION OF ELECTRON BEAM WELDING MACHINES - PART 1: PRINCIPLES AND ACCEPTANCE CONDITIONS
Hardcopy , PDF
English
01-01-2008
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Foreword
Introduction
1 Scope
2 Normative references
3 Symbols and abbreviated terms
4 Conditions for acceptance inspection
5 Principles of acceptance inspection
6 Acceptance inspection
7 Supplementary acceptance inspections
Annex A (informative) Procedures for inspection of
pressure rise rate
Bibliography
Describes requirements for acceptance inspection of electron beam welding machines preferably when first installed on the user's premises.
| DocumentType |
Standard
|
| Pages |
20
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Supersedes |
| Standards | Relationship |
| ISO 14744-1:2008 | Identical |
| NS EN ISO 14744-1 : 2ED 2008 | Identical |
| EN ISO 14744-1:2008 | Identical |
| DIN EN ISO 14744-1:2008-09 | Identical |
| NEN EN ISO 14744-1 : 2008 | Identical |
| NF EN ISO 14744-1 : 2008 | Identical |
| BS EN ISO 14744-1:2008 | Identical |
| NBN EN ISO 14744-1 : 2008 | Identical |
| UNE-EN ISO 14744-1:2009 | Identical |
| ISO 14744-5:2000 | Welding — Acceptance inspection of electron beam welding machines — Part 5: Measurement of run-out accuracy |
| ISO 17662:2016 | Welding — Calibration, verification and validation of equipment used for welding, including ancillary activities |
| IEC 60204-1:2016 | Safety of machinery - Electrical equipment of machines - Part 1: General requirements |
| ISO 14744-3:2000 | Welding — Acceptance inspection of electron beam welding machines — Part 3: Measurement of beam current characteristics |
| ISO 14744-4:2000 | Welding — Acceptance inspection of electron beam welding machines — Part 4: Measurement of welding speed |
| ISO 14744-6:2000 | Welding — Acceptance inspection of electron beam welding machines — Part 6: Measurement of stability of spot position |
| ISO 14744-2:2000 | Welding — Acceptance inspection of electron beam welding machines — Part 2: Measurement of accelerating voltage characteristics |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.