I.S. EN ISO 15118-3:2016
Current
The latest, up-to-date edition.
ROAD VEHICLES - VEHICLE TO GRID COMMUNICATION INTERFACE - PART 3: PHYSICAL AND DATA LINK LAYER REQUIREMENTS (ISO 15118-3:2015)
Hardcopy , PDF
English
01-01-2016
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
National Foreword
European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Conventions
6 System architecture
7 Connection coordination
8 Timings and constants
9 Matching EV - EVSE process
10 EMC requirements
11 Signal coupling
12 Layer 2 interfaces
Annex A (normative) - HomePlug Green PHY on control
pilot line
Annex B (informative) - IEEE 1901.2 G3-PLC profile on
control pilot line
Bibliography
Defines the requirements of the physical and data link layer for a high-level communication, directly between battery electric vehicles (BEV) or plug-in hybrid electric vehicles (PHEV), termed as EV (electric vehicle) [ISO-1], based on a wired communication technology and the fixed electrical charging installation [Electric Vehicle Supply Equipment (EVSE)] used in addition to the basic signalling, as defined in [IEC-1].
| DocumentType |
Standard
|
| Pages |
96
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Standards | Relationship |
| EN ISO 15118-3:2016 | Identical |
| ISO 15118-3:2015 | Identical |
| IEC 62196-2:2016 | Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories |
| IEC TS 62763:2013 | Pilot function through a control pilot circuit using PWM (pulse width modulation) and a control pilot wire |
| IEC 62196-3:2014 | Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3: Dimensional compatibility and interchangeability requirements for d.c. and a.c./d.c. pin and contact-tube vehicle couplers |
| ISO 15118-1:2013 | Road vehicles Vehicle to grid communication interface Part 1: General information and use-case definition |
| ISO 15118-2:2014 | Road vehicles — Vehicle-to-Grid Communication Interface — Part 2: Network and application protocol requirements |
| IEC 61851-1:2017 | Electric vehicle conductive charging system - Part 1: General requirements |
| IEC 62196-1:2014 | Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.