I.S. EN ISO 16495:2013
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PACKAGING - TRANSPORT PACKAGING FOR DANGEROUS GOODS - TEST METHODS (ISO 16495:2013)
Hardcopy , PDF
English
01-01-2013
27-06-2022
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test report
5 Selection and preparation of packaging, IBCs and
large packaging for testing
6 Test methods
7 Facilities for testing
Annex A (normative) - Test report
Annex B (normative) - Packaging specifications
Annex C (normative) - IBC specifications
Annex D (normative) - Large packaging specifications
Annex E (informative) - Type of contents
Annex F (normative) - Drop test
Annex G (normative) - Leakproofness test
Annex H (normative) - Hydraulic pressure test
Annex I (normative) - Stacking test
Annex J (normative) - Water spray test
Annex K (normative) - Bottom lift test
Annex L (normative) - Top lift test
Annex M (normative) - Tear test
Annex N (normative) - Topple test
Annex O (normative) - Righting test
Annex P (normative) - Puncture test
Annex Q (normative) - Vibration test
Bibliography
Describes the information needed for the design type testing of packaging, Intermediate Bulk Containers (IBCs) and large packaging intended for use in the transport of dangerous goods.
| DevelopmentNote |
Supersedes I.S. EN ISO 16104 & I.S. EN ISO 16467. (09/2013)
|
| DocumentType |
Standard
|
| Pages |
67
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| EN ISO 16495:2013 | Identical |
| ISO 16495:2013 | Identical |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| ISO 2875:2000 | Packaging — Complete, filled transport packages and unit loads — Water-spray test |
| ISO 2206:1987 | Packaging — Complete, filled transport packages — Identification of parts when testing |
| ISO 2248:1985 | Packaging — Complete, filled transport packages — Vertical impact test by dropping |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.