I.S. EN ISO 2818:1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS - PREPARATION OF TEST SPECIMENS BY MACHINING
Hardcopy , PDF
English
01-01-1997
08-02-2019
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Committees responsible
National foreword
Introduction
1 Method
2 Normative references
3 Definitions
4 Test specimens
5 Machinery and tools
6 Procedure
7 Test reports
Annex
A (informative) Bibliography
Table
1 Recommended machining conditions for four types of test
specimen and for notches
Figures
1 Geometry of the active part of cutting tools
2 Shape of milling chips
3 Chip thickness ds in the range between 0.003 mm and 0.007 mm
versus rotational speed n and feed speed vf of a
milling machine (R = 40 mm)
4 Example of a circular cutter (half-section of a diamond-
edged cutter)
Gives the general principles and procedures to be followed when machining and notching test specimens from compression-moulded and injection-moulded plastics, extruded sheets, plates and partially finished or wholly finished products.
| DocumentType |
Standard
|
| Pages |
24
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NF EN ISO 2818 : 1997 | Identical |
| BS EN ISO 2818 : 1997 | Identical |
| EN ISO 2818:1996 | Identical |
| NS EN ISO 2818 : 1ED 1997 | Identical |
| NEN EN ISO 2818 : 1997 | Identical |
| NBN EN ISO 2818 : 1997 | Identical |
| ISO 2818:1994 | Identical |
| UNE-EN ISO 2818:1997 | Identical |
| DIN EN ISO 2818:1997-06 | Identical |
Important note : Users cannot be edited or removed once added to your Multi user PDF.