I.S. EN ISO 8062-3:2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - DIMENSIONAL AND GEOMETRICAL TOLERANCES FOR MOULDED PARTS - PART 3: GENERAL DIMENSIONAL AND GEOMETRICAL TOLERANCES AND MACHINING ALLOWANCES FOR CASTINGS
Hardcopy , PDF
02-03-2023
English
01-01-2007
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviated terms
5 Tolerance grades
5.1 General
5.2 Dimensional casting tolerance grades (DCTG)
5.3 Geometrical casting tolerance grades (GCTG)
6 Surface mismatch (SMI)
7 Wall thickness
8 Required machining allowances (RMA)
8.1 General
8.2 Required machining allowance grades (RMAG)
9 Indication on drawings
9.1 Indication of general dimensional casting tolerances
9.2 Indication of required machining allowances
9.3 Indication of geometrical casting tolerances
10 Rejection
Annex A (informative) Casting tolerances and geometrical
Tolerances
Annex B (informative) Required machining allowance grades
(RMAG)
Annex C (informative) Concept of general tolerancing of
characteristics
Annex D (informative) Datums for general geometrical tolerances
Annex E (informative) Application of general geometrical
tolerances for castings
Annex F (informative) Relation to the GPS matrix model
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.