I.S. EN ISO 8251:2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
ANODIZING OF ALUMINIUM AND ITS ALLOYS - MEASUREMENT OF ABRASION RESISTANCE OF ANODIC OXIDATION COATINGS
Hardcopy , PDF
English
01-01-2011
03-10-2018
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Characteristics of abrasion tests
5 Abrasive-wheel-wear test
6 Abrasive jet test
7 Falling sand abrasion test
8 Test report
Annex A (normative) - Preparation of standard specimen
Annex B (informative) - Depth survey of abrasion resistance
Annex C (informative) - Design of abrasive-wheel-wear test
apparatus
Annex D (informative) - Design of abrasive jet test apparatus
Annex E (informative) - Design of falling sand abrasion test
apparatus
Bibliography
Describes following three test methods: a) abrasive-wheel-wear test method, determining the wear resistance and the wear index of anodic oxidation coatings on flat specimens of aluminium and its alloys; b) abrasive jet test method, comparing the resistance to abrasion of anodic oxidation coatings on aluminium and its alloys with that of a standard specimen or, alternatively, a reference specimen, by use of a jet of abrasive particles; c) falling sand abrasion method, determining the abrasion resistance with falling sand applied to thin anodic oxidation coatings.
| DevelopmentNote |
Supersedes I.S. EN 12373-10 and I.S. EN 12373-9. (02/2011)
|
| DocumentType |
Standard
|
| Pages |
41
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| EN ISO 8251:2011 | Identical |
| ISO 8251:2011 | Identical |
| ISO 2106:2011 | Anodizing of aluminium and its alloys — Determination of mass per unit area (surface density) of anodic oxidation coatings — Gravimetric method |
| ISO 10074:2010 | Anodizing of aluminium and its alloys — Specification for hard anodic oxidation coatings on aluminium and its alloys |
| ISO 8486-1:1996 | Bonded abrasives — Determination and designation of grain size distribution — Part 1: Macrogrits F4 to F220 |
| ISO 565:1990 | Test sieves — Metal wire cloth, perforated metal plate and electroformed sheet — Nominal sizes of openings |
| ISO 6344-1:1998 | Coated abrasives — Grain size analysis — Part 1: Grain size distribution test |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.