Foreword
1 Scope
2 Normative references
3 Definitions
4 General conditions for measurement
4.1 General
5 Requirements
5.1 General
5.2 Safety
5.3 Local Oscillator(s) (LO) frequency
5.4 Radiation from the outdoor unit
5.5 Immunity
5.6 Documentation
6 Recommendation
6.1 Documentation
6.2 Radio frequency input range(s)
6.3 Intermediate Frequency (IF) output range
6.4 Figure of merit
6.5 Radiation from outdoor unit
6.6 Antenna sub-system
6.7 Low-Noise Block (LNB) down-converter
6.8 Internal immunity to unwanted signals
6.9 Power supply
6.10 Commands waveguides [13a]
Annex A (normative): General conditions for
measurement
A.1 Standard atmospheric conditions
A.2 Power supply
A.3 Test site
A.4 Accuracy of the measuring instruments
A.5 Stabilisation period
A.6 Presentation of results
A.7 Deviations
A.8 Radio-frequency input signals
Annex B (normative): Radiation measurement in the
frequency range from 1 GHz to
18 GHz
B.1 Measuring equipment
B.2 Measuring set-u
B.3 Site checking and calibration
B.4 Measurement procedure
B.5 Presentation of the results
Annex C (normative): Radiation measurements in the
frequency range from 30 to 1000
MHz
C.1 Introduction
C.2 Measurements in the frequency range 30 MHz - 300
MHz
C.3 Measurements in the frequency range 300 - 1000 MHz
Annex D (normative): Measurement of G/T ratio by direct
method
D.1 Introduction
D.2 Method of measurement
Annex E (normative): Antenna sub-system noise
temperature measurement method
Annex F (informative): G/T ratio (clear sky conditions)
F.1 G/T ratio indirect measurement
F.2 G/T calculation for a particular antenna
Annex G (informative): Protection ratio
Annex H (informative): Dimensions in millimetres of
waveguide flanges
H.1 Dimensions of Type B flanges in millimetres for
ordinary rectangular
H.2 Dimensions of flanges in millimetres for
circular waveguides [13b]
Annex J (informative): Installation
History