• IEC 60068-2-9:1975

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    Environmental testing - Part 2: Tests. Guidance for solar radiation testing

    Available format(s):  Hardcopy, PDF, PDF 3 Users, PDF 5 Users, PDF 9 Users

    Superseded date:  27-04-2010

    Language(s): 

    Published date:  01-01-1975

    Publisher:  International Electrotechnical Committee

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Warning note
    1 Introduction
    2 Irradiance and spectral distribution of test source
    3 Test procedure and duration
    4 Other environmental factors to be considered
    5 Radiation source
    6 Instrumentation
    7 Preparation of test facilities and specimens
    8 Interpretation of results
    9 Hazards and personnel safety
    Bibliography
    Figures
    Annexes
    A - Calculation of adjustment to irradiance
    B - Heat transfer through substrate
    ZA - (normative) - Normative references to international
         publications with their corresponding European
         publications

    Abstract - (Show below) - (Hide below)

    Describes methods of simulation designed to examine the effect of solar radiation on equipment and components at the surface of the earth. Should be used with IEC 68-2-5.

    General Product Information - (Show below) - (Hide below)

    Committee TC 104
    Development Note Also numbered as BS EN 60068-2.9. (09/2005)
    Document Type Standard
    Publisher International Electrotechnical Committee
    Status Superseded
    Superseded By

    Standards Referenced By This Book - (Show below) - (Hide below)

    PD IEC TR 60721-4-6:2002 Ship environmentClassification of environmental conditions. Guidance for the correlation and transformation of environmental condition classes of IEC 60721-3 to the environmental tests of IEC 60068
    BS EN 61300-2-30:1997 Fibre optic interconnecting devices and passive components. Basic test and measurement procedures. Tests Solar radiation
    BS 2011-2.1Sa:1977 Environmental testing. Tests Test Sa. Simulated solar radiation at ground level
    UNE-IEC/TS 61827:2011 Electrical installations for lighting and beaconing of aerodromes - Characteristics of inset and elevated luminaires used on aerodromes and heliports
    I.S. EN 181000:1994 FIBRE OPTIC BRANCHING DEVICES (GENERIC SPECIFICATION)
    I.S. EN 60945:2002 MARITIME NAVIGATION AND RADIOCOMMUNICATION EQUIPMENT AND SYSTEMS - GENERAL REQUIREMENTS - METHODS OF TESTING AND REQUIRED TEST RESULTS
    DIN EN ISO 8980-4 E : 2006 OPHTHALMIC OPTICS - UNCUT FINISHED SPECTACLE LENSES - PART 4: SPECIFICATIONS AND TEST METHODS FOR ANTI-REFLECTIVE COATINGS
    EN 60945:2002 Maritime navigation and radiocommunication equipment and systems - General requirements - Methods of testing and required test results
    EN 181000:1994 Generic Specification: Fibre optic branching devices
    EN 180000:1995 Generic specification: Fibre optic attenuators
    NF EN 50483-6 : 2009 TEST REQUIREMENTS FOR LOW VOLTAGE AERIAL BUNDLED CABLE ACCESSORIES - PART 6: ENVIRONMENTAL TESTING
    14/30299825 DC : 0 BS EN 50289-4-17 - COMMUNICATION CABLES - SPECIFICATIONS FOR TEST METHODS - PART 4-17: TEST METHODS FOR UV RESISTANCE EVALUATION OF THE SHEATH OF ELECTRICAL AND OPTICAL FIBRE CABLE
    BS EN 50483-6:2009 Test requirements for low voltage aerial bundled cable accessories Environmental testing
    BS EN 60945:2002 Maritime navigation and radiocommunication equipment and systems. General requirements. Methods of testing and required test results
    BS EN 181000:1995 Harmonized system of quality assessment for electronic components. Generic specification. Fibre optic branching devices
    00/200618 DC : DRAFT JAN 2000 IEC 61827 ED.1 - ELECTRICAL INSTALLATION AND BEACONING OF AERODROMES - CHARACTERISTICS OF INSET AND ELEVATED LUMINAIRES USED ON AERODROMES
    CEI EN 60945 : 2003 MARITIME NAVIGATION AND RADIOCOMMUNICATION EQUIPMENT AND SYSTEMS - GENERAL REQUIREMENTS - METHODS OF TESTING AND REQUIRED TEST RESULTS
    BS ISO 15003:2006 Agricultural engineering. Electrical and electronic equipment. Testing resistance to environmental conditions
    I.S. EN ISO 8980-4:2007 OPHTHALMIC OPTICS - UNCUT FINISHED SPECTACLE LENSES - PART 4: SPECIFICATIONS AND TEST METHODS FOR ANTI-REFLECTIVE COATINGS
    11/30241337 DC : DRAFT JAN 2011 BS EN 61757-1 - FIBRE OPTIC SENSORS - PART 1: GENERIC SPECIFICATION
    05/30133428 DC : DRAFT MAY 2005 IEC 62395-1 - ELECTRICAL HEAT TRACING SYSTEMS FOR INDUSTRIAL AND COMMERCIAL APPLICATIONS - PART 1: GENERAL AND TESTING REQUIREMENTS
    ISO 15003:2006 Agricultural engineering Electrical and electronic equipment Testing resistance to environmental conditions
    PREN 50289-4-17 : DRAFT 2014 COMMUNICATION CABLES - SPECIFICATIONS FOR TEST METHODS - PART 4-17: TEST METHODS FOR UV RESISTANCE EVALUATION OF THE SHEATH OF ELECTRICAL AND OPTICAL FIBRE CABLE
    I.S. EN 50483-6:2009 TEST REQUIREMENTS FOR LOW VOLTAGE AERIAL BUNDLED CABLE ACCESSORIES - PART 6: ENVIRONMENTAL TESTING
    IEC TR 60721-4-6:2001+AMD1:2003 CSV Classification of environmental conditions - Part 4-6: Guidance for the correlation and transformation of environmental condition classes of IEC 60721-3 to the environmental tests of IEC 60068 - Ship environment
    CEI EN 61300-2-30 : 1997 FIBRE OPTIC INTERCONNECTING DEVICES AND PASSIVE COMPONENTS - BASIC TEST AND MEASUREMENT PROCEDURES - PART 2-30: TESTS - SOLAR RADIATION
    IEC TS 61827:2004 Electrical installations for lighting and beaconing of aerodromes - Characteristics of inset and elevated luminaires used on aerodromes and heliports
    XP C20 540 : 2002 XP ENVIRONMENTAL TESTING - TEST METHODS - CLIMATIC AGEING TEST OF EQUIPMENT AND SYNTHETIC MATERIALS FOR OUTDOOR USE
    01/205976 DC : DRAFT AUG 2001 IEC 60519-10 - SAFETY IN ELECTROHEAT INSTALLATIONS - PART 10: PARTICULAR REQUIREMENTS FOR ELECTRICAL RESISTANCE TRACE HEATING FOR INDUSTRIAL AND COMMERCIAL APPLICATIONS
    BS EN 180000:1996 Harmonized system of quality assessment for electronic components. Generic specification: Fibre optic attenuators
    PD 6521:1988 Summaries of test methods for environmental testing of electrotechnical products
    03/316517 DC : DRAFT OCT 2003
    IEC 61300-2-30:1995 Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-30: Tests - Solar radiation
    BS EN ISO 8980-4:2006 Ophthalmic optics. Uncut finished spectacle lenses Specifications and test methods for anti-reflective coatings
    IEC 61747-1:1998+AMD1:2003 CSV Liquid crystal and solid-state display devices - Part 1: Generic specification
    ISO 8980-4:2006 Ophthalmic optics Uncut finished spectacle lenses Part 4: Specifications and test methods for anti-reflective coatings
    IEC 60945:2002 Maritime navigation and radiocommunication equipment and systems - General requirements - Methods of testing and required test results
    EN ISO 8980-4:2006 Ophthalmic optics - Uncut finished spectacle lenses - Part 4: Specifications and test methods for anti-reflective coatings (ISO 8980-4:2006)
    EN 180000 : 1995 GENERIC SPECIFICATION: FIBRE OPTIC ATTENUATORS
    ETR 344 : 20001 TERMINAL EQUIPMENT (TE) - THE TECHNICAL FEASIBILITY OF A HARMONIZED PLUG AND SOCKET STANDARD
    13/30264596 DC : 0 BS EN 60747-14-7 ED 1.0 - SEMICONDUCTOR DEVICES - PART 14-7: SEMICONDUCTOR SENSORS - FLOW METER
    13/30264600 DC : 0 BS EN 60747-14-8 ED 1.0 - SEMICONDUCTOR DEVICES - PART 14-8: SEMICONDUCTOR SENSORS - CAPACITIVE DEGRADATION SENSOR OF LIQUID
    03/304151 DC : DRAFT MAR 2003 IEC 60519-10-1 - SAFETY IN ELECTROHEAT INSTALLATIONS - PART 10-1: PARTICULAR REQUIREMENTS FOR ELECTRICAL RESISTANCE TRACE HEATING SYSTEMS FOR INDUSTRIAL AND COMMERCIAL APPLICATIONS
    BS 2011-4.2:1984 Environmental testing. Miscellaneous Guidance on the application of the tests of BS 2011 to simulate the effects of storage
    IEEE C37.24-2003 IEEE Guide for Evaluating the Effect of Solar Radiation on Outdoor Metal-Enclosed Switchgear
    CEI EN 50483-6 : 2011 TEST REQUIREMENTS FOR LOW VOLTAGE AERIAL BUNDLED CABLE ACCESSORIES - PART 6: ENVIRONMENTAL TESTING
    17/30325894 DC : 0 BS EN 17075 - WATER QUALITY - GENERAL REQUIREMENTS AND PERFORMANCE TEST PROCEDURES FOR WATER MONITORING EQUIPMENT - MEASURING DEVICES
    IEC 60300-3-5:2001 Dependability management - Part 3-5: Application guide - Reliability test conditions and statistical test principles
    I.S. CECC 86000:1993 CONNECTOR SETS FOR OPTICAL FIBRES AND CABLES - PART 1: REQUIREMENTS, TEST METHODS AND QUALIFICATION APPROVAL PROCEDURES (GENERIC SPECIFICATION)
    DIN EN ISO 8980-4:2006-11 Ophthalmic optics - Uncut finished spectacle lenses - Part 4: Specifications and test methods for anti-reflective coatings (ISO 8980-4:2006)
    EN 61300-2-30 : 1997 FIBRE OPTIC INTERCONNECTING DEVICES AND PASSIVE COMPONENTS - BASIC TEST AND MEASUREMENT PROCEDURES - TESTS - SOLAR RADIATION
    EN 50483-6:2009 Test requirements for low voltage aerial bundled cable accessories - Part 6: Environmental testing
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective