IEC 60107-4:1988+AMD1:1999 CSV
Current
The latest, up-to-date edition.
Recommended methods of measurement on receivers for television broadcast transmissions - Part 4: Electrical measurements on multichannel sound television receivers using the two-carrier FM-system
Hardcopy , PDF , PDF 3 Users , PDF 5 Users , PDF 9 Users
English - French
04-06-1999
FOREWORD
CHAPTER I: GENERAL
SECTION ONE - INTRODUCTION
1 Scope
2 Object
SECTION TWO - EXPLANATION OF TERMS
3 Definition of modes
4 Pilot signal
5 Identification signal modulation
6 Modes of operation
6.1 Dual-sound mode
6.2 Stereophonic mode
6.3 Monaural mode
SECTION THREE - GENERAL NOTES ON MEASUREMENTS
7 General conditions
8 Standard output power and voltage
8.1 Standard output power for loudspeaker
8.2 Standard line output voltage
9 Setting of tone controls
10 Setting of stereo balance control
11 Receiver tuning
21 Radio-frequency signals
13 Weighted and unweighted audio noise measurement
14 Standard measuring conditions
SECTION FOUR - SUPPRESSION OF LINE-SCAN FREQUENCY
INTERFERENCE AT THE AUDIO OUTPUTS
15 Introduction
16 Definition
17 Method of measurement
18 Presentation of results
CHAPTER II: ELECTRICAL RESPONSE MEASUREMENTS
SECTION FIVE - AUDIO-FREQUENCY RESPONSE CHARACTERISTICS
19 Definition
20 Method of measurement in the dual-sound mode
21 Method of measurement in the stereophonic mode
22 Presentation of results
CHAPTER III: AUDIO-FREQUENCY NON-LINEARITY DISTORTION
SECTION SIX - HARMONIC DISTORTION VERSUS OUTPUT POWER
23 Definition
24 Method of measurement in the dual-sound mode
25 Method of measurement in the stereophonic mode
26 Presentation of results
SECTION SEVEN - HARMONIC DISTORTION VERSUS MODULATION
FACTOR
27 Definition
28 Method of measurement in the dual-sound mode
29 Method of measurement in the stereophonic mode
30 Presentation of results
CHAPTER IV: INTERNALLY GENERATED INTERFERENCE
SECTION EIGHT - SIGNAL-TO-NOISE RADIO INCLUDING PICTURE
TO SOUND CROSSMODULATION
31 Introduction
32 Method of measurement in dual-sound mode
33 Method of measurement in the stereophonic mode
34 Presentation of results
CHAPTER V: MODE IDENTIFICATION
35 Definition
36 Method of measurement for critical video modulation
37 Method of measurement for critical audio modulation
38 Presentation of results
SECTION TEN - MODE IDENTIFICATION SENSITIVITY
39 Definition
40 Method of measurement in the dual-sound mode
41 Method of measurement in the stereophonic mode
42 Presentation of results
CHAPTER VI: AUDIO CHANNEL SEPARATION
43 Definition
44 Method of measurement
45 Presentation of results
SECTION TWELVE - STEREOPHONIC SEPARATION
46 Definition
47 Method of measurement
48 Presentation of results
Applies to television receivers designed for the reception of television broadcast transmissions with multichannel sound using the two-carrier FM system. This consolidated version consists of the first edition (1988) and its amendment 1 (1999). Therefore, no need to order amendment in addition to this publication.
DevelopmentNote |
Stability Date: 2030. (09/2017)
|
DocumentType |
Standard
|
Pages |
35
|
PublisherName |
International Electrotechnical Committee
|
Status |
Current
|
Standards | Relationship |
DIN IEC 60107-4:2000-09 | Identical |
CEI EN 60107-2 : 1998 | METHODS OF MEASUREMENT ON RECEIVERS FOR TELEVISION BROADCAST TRANSMISSIONS - PART 2: AUDIO CHANNELS - GENERAL METHODS AND METHODS FOR MONOPHONIC CHANNELS |
I.S. EN 61079-5:1994 | METHODS OF MEASUREMENT ON RECEIVERS FOR SATELLITE BROADCAST TRANSMISSION IN THE 12 GHZ BAND - PART 5: ELECTRICAL MEASUREMENTS ON DECODER UNITS FOR MAC/PACKET SYSTEMS |
IEC 60107-2:1997 | Methods of measurement on receivers for television broadcast transmissions - Part 2: Audio channels - General methods and methods for monophonic channels |
I.S. EN 60107-1:1999 | METHODS OF MEASUREMENT ON RECEIVERS FOR TELEVISION BROADCAST TRANSMISSION - PART 1: GENERAL CONSIDERATIONS - MEASUREMENTS ON DISPLAYS AT RADIO AND VIDEO FREQUENCIES |
BS EN 60107-1:1997 | Methods of measurement on receivers for television broadcast transmission General considerations. Measurements on displays at radio and video frequencies |
BS 3549-2:1981 | Methods of measuring and expressing the performance of television receivers Electrical and acoustic measurements at audio-frequencies |
CEI EN 60107-1 : 1998 | METHODS OF MEASUREMENT ON RECEIVERS FOR TELEVISION BROADCAST TRANSMISSIONS - PART 1: GENERAL CONSIDERATIONS - MEASUREMENTS AT RADIO AND VIDEO FREQUENCIES |
BS EN 61079-5:1995 | Methods of measurement on receivers for satellite broadcast transmissions in the 12 GHz band Electrical measurements on decoder units for MAC/packet systems |
IEC 61079-5:1993 | Methods of measurement on receivers for satellite broadcast transmissions in the 12 GHz band - Part 5: Electrical measurements on decoder units for MAC/packet systems |
BS EN 60107-2:1997 | Methods of measurement on receivers for television broadcast transmission Audio channels. General methods and methods for monophonic channels |
IEC 60107-1:1997 | Methods of measurement on receivers for television broadcast transmissions - Part 1: General considerations - Measurements at radio and video frequencies |
EN 61079-5:1993 | Methods of measurement on receivers for satellite broadcast transmissions in the 12 GHz band - Part 5: Electrical measurements on decoder units for MAC/Packet systems |
CEI EN 61079-5 : 1997 | METHODS OF MEASUREMENT ON RECEIVERS FOR SATELLITE BROADCAST TRANSMISSIONS IN THE 12 GHZ BAND PART 5: ELECTRICAL MEASUREMENTS ON DECODER UNITS FOR MAC/PACKET SYSTEMS |
EN 60107-2:1997/corrigendum:1997 | METHODS OF MEASUREMENT ON RECEIVERS FOR TELEVISION BROADCAST TRANSMISSIONS - AUDIO CHANNELS - GENERAL METHODS AND METHODS FOR MONOPHONIC CHANNELS |
EN 60107-1:1997 | Methods of measurement on receivers for television broadcast transmissions - Part 1: General considerations - Measurements at radio and video frequencies |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.