IEC 60244-6:1976

FOREWORD
PREFACE
INTRODUCTION
CHAPTER 1: GENERAL
Clause
1. Scope
2. Object
SECTION ONE - DEFINITIONS AND GENERAL NOTES ON INTERFERENCE
              CAUSED BY RADIO TRANSMITTERS
3. Terms and definitions
4. Spurious radiation and cabinet radiation
5. Measurement of cabinet radiation
6. Shielding effectiveness of enclosures and terminal
    interference voltages
SECTION TWO - GENERAL REQUIREMENTS CONCERNING MEASURING
              EQUIPMENT AND TEST CONDITIONS
7. Measuring equipment
8. General test conditions
CHAPTER II: MEASUREMENTS AT FREQUENCIES BETWEEN 30 MHz AND 1 GHz
9. Introduction
10. Application
11. Radiation test site
12. Measuring equipment
13. Test conditions
14. Arrangement of the transmitter
15. Arrangement of the test load and connection to the
    transmitter
16. Connection of the transmitter of the power supply
17. Arrangement of measuring equipment and connection to
    the mains supply
18. Methods of measurement
19. Presentation of the results
SECTION FOUR - RADIATION FROM MEDIUM-SIZED TRANSMITTERS
               MEASURED AT A DISTANCE OF 30 M
20. Introduction
21. Application
22. Radiation test site
23. Measuring equipment
24. Test conditions
25. Arrangement of the transmitter
26. Arrangement of the test load and connection to the
    transmitter
27. Connection of the transmitter of the power supply
28. Arrangement of measuring equipment and connection to
    the mains supply
29. Methods of measurement
30. Presentation of the results
SECTION FIVE - LARGE TRANSMITTERS
31. Application
32. General consideration concerning the measurement of
    cabinet radiation from large transmitters
33. Code of practice
CHAPTER III: MEASUREMENTS AT FREQUENCIES BETWEEN 130 kHz AND
             30 MHz
SECTION SIX - SMALL TRANSMITTERS
34. Application
35. General consideration concerning the measurement of cabinet
    radiation from small transmitters
SECTION SEVEN - RADIATION FROM MEDIUM-SIZED TRANSMITTERS
                MEASURED AT A DISTANCE OF 30 M OR 100 M
36. Introduction
37. Application
38. Radiation test site
39. Measuring equipment
40. Arrangement of measuring equipment
41. Test conditions
42. Methods of measurement
43. Presentation of the results
SECTION EIGHT - LARGE TRANSMITTERS
44. Application
45. General consideration concerning the measurement of cabinet
    radiation from large transmitters
46. Code of practice
APPENDIX A - References to other publications
APPENDIX B - Relationship between radiated power, field strength,
             aerial height and measuring distance
APPENDIX C - Tests for checking the suitability of test sites
             for radiation measurements at frequencies between
             30 MHz and 1 GHz
APPENDIX D - Tests for checking the suitability of aerials used
             for radiation measurements at frequencies between
             30 MHz and 1 GHz
APPENDIX E - Method of measuring cabinet radiation at frequencies
             between 130 kHz and 30 kHz in a test room with
             reflecting walls
APPENDIX F - Artificial-mains networks - Principle and general
             requirements
APPENDIX G - Examples of artificial-mains networks for transmitters
             requiring a current less than 25 A

Describes the conditions and methods to measure unwanted radiations originating from sources other than the aerial or aerial system of radio transmitters. The standard is intended to be used in conjunction with IEC 60244-1. The methods of measurement described in this standard are intended for type tests but they may also be used for acceptance tests and factory tests. Does not apply to transmitters in which the aerial cannot be disconnected or disabled and replaced by a test load.