IEC 60317-0-4:2015

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions and general notes
   on tests and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) - Nominal cross-sectional
        areas for preferred and intermediate
        sizes
Bibliography

IEC 60317-0-4:2015 specifies general requirements of glass-fibre wound, resin or varnish impregnated, bare or enamelled rectangular copper wire. The range of nominal conductor dimensions is given in the relevant specification sheet. This third edition cancels and replaces the second edition published in 1997, Amendment 1:1999 and Amendment 2:2005. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:

- addition of dimensional requirements for grade 1 enamelled wire in Table 4;

- addition of dielectric breakdown requirements for grade 1 enamelled wire in Table 7. Keywords: insulated wires used for windings, copper wire



This publication is to be read in conjunction with IEC 60851 series.