IEC 60317-0-5:2006

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Definitions, general notes on methods of test and
   appearance
   3.1 Definitions
   3.2 General notes on methods of test
   3.3 Appearance
4 Dimensions
   4.1 Conductor dimensions
   4.2 Tolerance on conductor dimensions
   4.3 Rounding of corners
   4.4 Increase in dimensions due to the insulation
   4.5 Overall dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
   8.1 Mandrel winding test
   8.2 Adherence test
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) Nominal cross-sectional areas for
                      preferred and intermediate sizes

This part of IEC 60317 specifies general requirements of glass-fibre braided resin or varnish impregnated, bare or enamelled rectangular copper wire. The range of nominal conductor dimensions is given in the relevant specification sheet.