IEC 61340-2-3:2016 RLV
Current
The latest, up-to-date edition.
Electrostatics - Part 2-3: Methods of test for determining the resistance and resistivity of solid materials used to avoid electrostatic charge accumulation
Hardcopy , PDF , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
23-06-2016
Important note : Users cannot be edited or removed once added to your Multi user PDF.
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Conditioning and test environment
5 Selection of test method
6 Resistance measurements for solid conductive materials
7 Resistance measurements for solid insulating materials
8 Resistance measurements for planar electrostatic
dissipative materials (used to avoid electrostatic
charge accumulation)
9 Conversion to resistivity values
10 Resistance measurements for non-planar materials
and products with small structures
11 Repeatability and reproducibility
12 Test report
Annex A (normative) - System verification
IEC 61340-2-3:2016 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition.
IEC 61340-2-3:2016 describes test methods for the determination of the electrical resistance and resistivity of solid materials used to avoid electrostatic charge accumulation, in which the measured resistance is in the range 10K Ohm to 1T Ohm. It takes account of existing IEC/ISO standards and other published information, and gives recommendations and guidelines on the appropriate method. This edition includes the following significant technical changes with respect to the previous edition:
a) a distinction has been introduced between instrumentation used for laboratory evaluations, instrumentation used for acceptance testing and instrumentation used for compliance verification (periodic testing);
b) an alternative electrode assembly is described, which can be used on non-planar products or when the dimensions of the product under test are too small to allow the larger electrode assembly to be used;
c) the formulae for calculating surface and volume resistivity have been modified to correspond with common industry practice in the main areas of application for the IEC 61340 series.
The contents of the corrigendum of July 2023 have been included in this copy.
| Committee |
TC 101
|
| DevelopmentNote |
Stability date: 2020. (06/2016)
|
| DocumentType |
Redline
|
| Pages |
88
|
| PublisherName |
International Electrotechnical Committee
|
| Status |
Current
|
| Supersedes |
| ISO 7619-1:2010 | Rubber, vulcanized or thermoplastic Determination of indentation hardness Part 1: Durometer method (Shore hardness) |
| ISO 3915:1981 | Plastics — Measurement of resistivity of conductive plastics |
| IEC 62631-3-3:2015 | Dielectric and resistive properties of solid insulating materials - Part 3-3: Determination of resistive properties (DC methods) - Insulation resistance |
| IEC 62631-3-2:2015 | Dielectric and resistive properties of solid insulating materials - Part 3-2: Determination of resistive properties (DC methods) - Surface resistance and surface resistivity |
| IEC 62631-3-1:2016 | Dielectric and resistive properties of solid insulating materials - Part 3-1: Determination of resistive properties (DC methods) - Volume resistance and volume resistivity - General method |
| ISO 1853:2011 | Conducting and dissipative rubbers, vulcanized or thermoplastic Measurement of resistivity |
| ISO 2951:2012 | Rubber, vulcanized or thermoplastic Determination of insulation resistance |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.