IEC PAS 62212:2001

1 METHODOLOGY
   1.1 Scope
   1.2 Purpose
   1.3 Classification
2 APPLICABLE DOCUMENTS
   2.1 IPC
   2.2 TAPPI
3 REQUIREMENTS
   3.1 Terms and Definitions
        3.1.1 Bagginess
        3.1.2 Binder
        3.1.3 Bundles
        3.1.4 Caliper Variation
        3.1.5 Conducting Particles
        3.1.6 Dents
        3.1.7 Dirt
        3.1.8 Edge Tear/Damaged Roll Edge
        3.1.9 Holes/Thin Spots
        3.1.10 Poor Formation
        3.1.11 Soft Roll/Telescoping
        3.1.12 Weight Variation
        3.1.13 Wrinkles/Folds
   3.2 Physical Requirements
        3.2.1 Product
        3.2.2 "E" Glass Fibers
        3.2.3 Diameter and Range
   3.3 Visual Requirements
        3.3.1 Visual/Appearance Procedures
        3.3.2 Visual/Appearance Defects
   3.4 Dimensional Requirements
        3.4.1 Roll Length
        3.4.2 Roll Width
4 QUALITY ASSURANCE
   4.1 Responsibility for Inspection
        4.1.1 Test Equipment and Inspection Facilities
        4.1.2 Standard Laboratory Conditions
   4.2 Preparation of Samples
   4.3 Inspection Procedure
        4.3.1 Classification of Major and Minor Visual
               Defects
        4.3.2 Sampling Plans
   4.4 Acceptability Quality Level
   4.5 Statistical Process Control (SPC)
5 PREPARATION FOR DELIVERY
   5.1 Roll Size
        5.1.1 Roll Length
        5.1.2 Roll Width
   5.2 Splices
   5.3 Preservation and Packaging
   5.4 Packing
   5.5 Labeling
6 NOTES
   6.1 Ordering Data

Covers mat made from non-woven « E » glass fibres intended as a reinforcing material in laminated plastics for electrical and electronic use. Determines the nomenclature, definitions, general comments, and physical requirements for mat made from non-woven « E » glass.