IEC TR 62453-502:2009

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, symbols, abbreviated terms
   and conventions
   3.1 Terms and definitions
   3.2 Symbols and abbreviated terms
   3.3 Conventions
        3.3.1 Data type names and references to data types
        3.3.2 Vocabulary for requirements
4 Bus category
5 Access to instance and device data
6 Protocol specific behavior
7 Protocol specific usage of general data types
8 Protocol specific common data types - DTMCIPDataTypeSchema
9 Network management data types
   9.1 General
   9.2 Node address
   9.3 Scanner/Master - Bus Parameter Set (CIP) -
        FDTCIPDTMParameterSchema
10 Communication data types
11 Channel parameter data types
12 Device identification
   12.1 Device type identification data types - FDTCIPIdentSchema
   12.2 Topology scan data types
   12.3 Scan identification data types - FDTCIPScanIdentSchema
   12.4 Device type identification data types -
        FDTCIPDeviceTypeIdentSchema
Annex A (informative) Implementation hints
Bibliography

IEC/TR 62453-502:2009(E) is a technical report and provides information for integrating the CIP technology into the COM based implementation of FDT interface specification (IEC/TR 62453-5). Communication Profile Family 2 (commonly known as CIP^TM1) defines communication profiles based on IEC 61158-2 Type 2, IEC 61158-3-2, IEC 61158-4-2, IEC 61158-5-2, and IEC 61158-6-2, IEC 62026-3. The basic profiles CP 2/1 (ControlNet^TM2), CP 2/2 (EtherNet/IP^TM3), and CP 2/3 (DeviceNet^TM1) are defined in IEC 61784-1 and IEC 61784-2. An additional communication profile (CompoNet^TM), also based on CIP^TM, is defined in [13]. It neither contains the FDT specification nor modifies it.