IEEE DRAFT C37.60 : D10 SEP 2000

Introduction
1 Scope
2 References
3 Definitions
4 Service Conditions
   4.1 Usual Service Conditions
   4.2 Unusual Service Conditions
5 Rating
   5.2 Rated Maximum Voltage
   5.3 Rated Frequency
   5.4 Rated Continuous Current
   5.5 Rated Minimum Tripping Current
       (for Series-Trip Reclosers)
   5.6 Rated Symmetrical Interrupting Current
   5.7 Rated Symmetrical Making Current
   5.8 Rated Impulse Withstand Voltage
   5.9 Rated Control Voltage and Ranges
6 Design Tests
   6.1 General
   6.2 Insulation (Dielectric Tests)
   6.3 Interruption Tests
   6.4 Making Current Tests
   6.5 Minimum Tripping Current Tests
   6.6 Radio Influence Voltage Tests (RIV)
   6.7 Surge Current Test; Series Coil Reclosers
   6.8 Temperature Rise Test
   6.9 Time-Current Tests
7 Production Tests
   7.1 Reclosing and Overcurrent Trip Calibration
   7.2 Control, Secondary Wiring and Accessory
       Devices Check Tests
   7.3 Dielectric Withstand Test; One Minute
       Dry Low Frequency
   7.4 Mechanical Operations Tests
   7.5 Water Leak Test
8 Construction Requirements
   8.1 Tank Construction: Submersible or Dry
       Vault Reclosers
   8.2 Grounding Provisions
   8.3 Insulating Medium Quantity Indicators
   8.4 Oil Sampling Provision (Submersible Reclosers)
   8.5 Manual Operating Provision
   8.6 Position Indicator
   8.7 Nameplate Markings
   8.8 Stored Energy Mechanism Charge Indicator
   8.9 Enclosure Integrity
   Annex A: X/R Ratios
   Annex B: Altitude Correction Factors
   Annex C: Bibliography

Applies to all overhead, pad mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers and fault interrupters for rated maximum voltages above 1000 V.