ISO 8132:2022

This document specifies the mounting dimensions required for the interchangeability of accessories for 16MPa (160bar) medium series cylinders in accordance with ISO6020‑1 and for 25MPa (250bar) series cylinders in accordance with ISO6022. The accessories have been designed specifically for use with cylinders manufactured in accordance with ISO6020‑1 and ISO6022, but this does not limit their application[1].

This document covers the following accessories, identified in accordance with ISO6099:

— AP2— rod clevis, female thread (see Figure1 and Table1);

— AF3— rod flange, circular (see Figure2 and Table2);

— AB4— clevis bracket, straight (see Figure3 and Table3);

— AB3— clevis bracket, in angle (see Figure4 and Table4);

— AT4— trunnion bracket (see Figure5 and Table5);

— AA4-R— pivot pin, plain bearing (snap ring type) (see Figure6 and Table6);

— AA4-S — pivot pin, plain bearing (split pin type) (see Figure7 and Table7);

— AA6-R — pivot pin, spherical bearing (snap ring type) (see Figure6 and Table6);

— AA6-S— pivot pin, spherical bearing (split pin type) (see Figure7 and Table7);

— AP6— rod eye spherical, female thread (see Figure8 and Table8);

— AP4— rod eye plain, female thread (see Figure9 and Table9).

These accessories are used on hydraulic cylinders for mechanically transmitting the cylinder force. The design of these accessories is based on the maximum forces resulting from the specified internal diameters of the cylinders and pressures according to ISO3320 and ISO2944.

This document applies only to the dimensional criteria of products manufactured in conformity with this document; it does not apply to their functional characteristics.

[1]1bar=0,1MPa=10⁵Pa; 1MPa=1N/mm².