ISO/FDIS 12129-1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Plain bearings — Tolerances — Part 1: Fits
Hardcopy , PDF , PDF 3 Users , PDF 5 Users , PDF 9 Users
19-12-2024
English
12-08-2024
Important note : Users cannot be edited or removed once added to your Multi user PDF.
This document specifies a system of fits applicable to metallic plain bearings used in general engineering for mean relative bearing clearances, ψm, of 0,56‰ up to 3,15‰. Other clearance ranges can be used depending upon the requirements in specific applications.
This system of fits is not applicable to half-bearings and bushes which, due to their special characteristics, are not measured by diameter but by wall thickness, and which are dimensionally changed on assembly. It is not applicable to profile bore or tilting pad bearings, or to cases where specific tolerances have been established by consideration of the bearing performance at both extremes of clearance.
This document is applicable preferably to bearings in rotating machines or transmissions, but it can be used similarly in other ranges of application.
| Committee |
ISO/TC 123/SC 3
|
| DocumentType |
Draft
|
| Pages |
10
|
| PublisherName |
International Organization for Standardization
|
| RevisionOf | |
| Status |
Superseded
|
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.