JIS B 1022:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Tolerances for fasteners -- Part 3: Plain washers for bolts, screws and nuts -- Product grades A and C
English
30-04-1999
23-12-2016
This Japanese Industrial Standard specifies a selection of tolerances for use in the preparation of the product standards for plain washers, grades A and C, for bolts, screws and nuts with nominal thread diameters from 1 mm up to and including 150 mm. Deviations from the tolerances specified in this Standard are permitted in product standards only for valid technical reasons. It is recommended that these tolerances also be used for non-standard plain washers. In cases where the maximum material principle according to JIS B 0023 is appropriate to certain features of certain products in the product standards, other tolerances may be applicable.
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
Japanese Standards Association
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| ISO 4759-3:1991 | Identical |
| JIS B 0023:1996 | Technical drawings -- Geometrical tolerancing -- Maximum material requirement and least material requirement |
| JIS B 1021:2003 | Tolerances for fasteners -- Part 1: Bolts, screws, studs and nuts -- Product grades A, B and C Part 1: Bolts, screws, studs and nuts - Product grades A, B and C |
| JIS B 1084:2007 | Fasteners -- Torque/clamp force testing |
| JIS B 1091:2003 | Fasteners -- Acceptance inspection |
| JIS B 1256:1998 | Plain washers |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.