JIS E 5402-1:2015

Introduction 1 Scope 2 Normative references 3 Information to be supplied by the purchaser4 Classification 4.1 Grades of steel 4.2 Types of heat-treatment condition on delivery 4.3 Testing category 4.4 Degree of finish 4.5 Tolerance category 5 Requirements 5.1 Chemical composition 5.2 Mechanical properties 5.3 Appearance and soundness 5.4 Machining allowances and dimensional tolerances 5.5 Residual imbalance 5.6 Marking 6 Manufacture 6.1 Steelmaking process 6.2 Manufacturing process 6.3 Removal of defective sections 6.4 Identification of the wheels during manufacture 6.5 Heat treatment 6.6 Machining and correction of imbalance 6.7 Removal of surface defects 6.8 Shot peening 7 Inspection 7.1 Responsibilities and type of inspection 7.2 Inspection of manufacture 7.3 Inspection of the characteristics of the wheels 7.4 Submission for inspection by the purchaser 7.5 Certification 7.6 Number of checks and tests 7.7 Sampling and preparation of samples and test pieces 7.8 Test methods 7.9 Retests 7.10 Conclusion of the inspection 8 Delivery 8.1 Protection against corrosion during transport 8.2 Protection against mechanical damage during transport Annex A (normative) Procedure for shot peening web surfaces of wheelsAnnex B (informative) Bibliography Annex 1 (informative) Comparison table of terms Annex 2 (informative) Comparison table between JIS and corresponding International Standard

This Standard specifies requirements for the manufacture and supply of rolled, forged, or cast solid wheels of unalloyed steels for rolling stock in accordance with Table 1, Table 1A, and Clause 4.

2015 [20/01/2015]2005(R2011) [25/05/2011]2005 ERRATA 2008 [01/08/2008]2005 [11/07/2005]98(R2003) [25/01/2003]98 [25/07/1998]