MIL-HDBK-704-2 Base Document:2004

FOREWORD
1. SCOPE
   1.1 Scope
2. APPLICABLE DOCUMENTS
   2.1 General
   2.2 Government documents
       2.2.1 Specifications, standards and handbooks
3. DEFINITIONS
   3.1 Acronyms and definitions
4. TEST METHODS INFORMATION
   4.1 Demonstration of compatibility
       4.1.1 Recording performance
   4.2 Calibration of test equipment
   4.3 Test methods
5. TEST METHODS
   METHOD SAC101 Load Measurements
   METHOD SAC102 Steady State Limits for Voltage and Frequency
   METHOD SAC103 No Test Required
   METHOD SAC104 Voltage Modulation
   METHOD SAC105 Frequency Modulation
   METHOD SAC106 Voltage Distortion Spectrum
   METHOD SAC107 Total Voltage Distortion
   METHOD SAC108 DC Voltage Component
   METHOD SAC109 Normal Voltage Transients
   METHOD SAC110 Normal Frequency Transients
   METHOD SAC201 Power Interrupt
   METHOD SAC301 Abnormal Steady State Limits for
   Voltage and Frequency
   METHOD SAC302 Abnormal Voltage Transients
   METHOD SAC303 Abnormal Frequency Transients
   METHOD SAC401 Emergency Steady State Limits for
   Voltage and Frequency
   METHOD SAC501 (No Test Required)
   METHOD SAC601 Power Failure (Single Phase)
   METHOD SAC602 (No Test Required)
   METHOD SAC603 Phase Reversal (Single Phase)
6. NOTES
   6.1 Intended use
   6.2 Single phase test numbers
   6.3 Subject term (keyword) listing
TABLE
CONCLUDING MATERIAL

Provides, as guidance, test methods used to demonstrate that single phase, 400 Hz, 115 volt utilization equipment is compatible with the electric power characteristics of the applicable edition(s) of MIL-STD-704.

This handbook provides, as guidance, test methods used to demonstrate that single phase, 400 Hz, 115 volt utilization equipment is compatible with the electric power characteristics of the applicable edition(s) of MIL-STD-704. This handbook is for guidance only and cannot be cited as a requirement.