MIL-HDBK-704-3 Base Document:2004

FOREWORD
1. SCOPE
   1.1 Scope
2. APPLICABLE DOCUMENTS
   2.1 General
   2.2 Government documents
       2.2.1 Specifications, standards and handbooks
3. DEFINITIONS
   3.1 Acronyms and definitions
4. TEST METHODS INFORMATION
   4.1 Demonstration of compatibility
       4.1.1 Recording performance
   4.2 Calibration of test equipment
   4.3 Test methods
5. TEST METHODS
   METHOD TAC101 Load Measurements
   METHOD TAC102 Steady State Limits for Voltage, Including
   Unbalance, and Frequency
   METHOD TAC103 Voltage Phase Difference
   METHOD TAC104 Voltage Modulation
   METHOD TAC105 Frequency Modulation
   METHOD TAC106 Voltage Distortion Spectrum
   METHOD TAC107 Total Voltage Distortion
   METHOD TAC108 DC Voltage Component
   METHOD TAC109 Normal Voltage Transients
   METHOD TAC110 Normal Frequency Transients
   METHOD TAC201 Power Interrupt
   METHOD TAC301 Abnormal Steady State Limits for Voltage
   and Frequency
   METHOD TAC302 Abnormal Voltage Transients
   METHOD TAC303 Abnormal Frequency Transients
   METHOD TAC401 Emergency Steady State Limits for Voltage
   and Frequency
   METHOD TAC501 (No Test Required)
   METHOD TAC601 Power Failure (Three Phase)
   METHOD TAC602 One and Two Phase Power Failures
   METHOD TAC603 Phase Reversal (Three Phase)
6. NOTES
   6.1 Intended use
   6.2 Subject term (keyword) listing
TABLE
CONCLUDING MATERIAL

Provides, as guidance, test methods used to demonstrate that three phase, 400 Hz, 115 volt utilization equipment is compatible with the electric power characteristics of the applicable edition(s) of MIL-STD-704.

This handbook provides, as guidance, test methods used to demonstrate that three phase, 400 Hz, 115 volt utilization equipment is compatible with the electric power characteristics of the applicable edition(s) of MIL-STD-704. This handbook is for guidance only and cannot be cited as a required.