MIL-PRF-39009 Revision E:2004

1. SCOPE
2. APPLICABLE DOCUMENTS
3. REQUIREMENTS
4. VERIFICATION
5. PACKAGING
6. NOTES
APPENDIX A - PROCEDURE FOR QUALIFICATION INSPECTION

Specifies the general requirements for nonestablished reliability (non-ER), and established reliability (ER), power type, wirewound, fixed resistors which utilize the principal of heat dissipation through a metal mounting surface.

This specification covers the general requirements for nonestablished reliability (non-ER), and established reliability (ER), power type, wirewound, fixed resistors which utilize the principal of heat dissipation through a metal mounting surface. These resistors have initial resistance tolerances of ±1 percent. These resistors are capable for continuous full load operation at an ambient temperature of +25OC, and when derated up to +250OC (see figure 1). These resistors should not be used in circuits where their ac performance is of critical importance in the operation of such circuits. However, provisions have been made in particular styles to minimize inductances (see 3.1). These resistors will have life failure rate levels (FRL) ranging from 1.0 percent to 0.001 percent per 1,000 hours (see 1.2.1.4). These FRL are established at a 60 percent confidence on the basis of the life tests. The FRL, identified by the appropriate symbol, is referred to operation at full rated wattage at +25OC, with a permissible change in resistance of ±2 percent as the criteria for failure.