NBN EN 13923 : 2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 General
6 Materials
   6.1 General
   6.2 Raw materials
   6.3 Chemical resistance
   6.4 Characteristics values for calculations
7 Design
   7.1 General
   7.2 The design factor
   7.3 Permissible strain
   7.4 Stress resultants
8 Design analysis method A
   8.1 General
   8.2 Calculations
   8.3 Prototype testing
9 Design analysis method B
   9.1 Calculation
10 Design documentation
11 Manufacturing
   11.1 Filament winding
   11.2 Protective layers
   11.3 Manufacturing specifications
12 Final acceptance testing
   12.1 General
   12.2 Acceptance testing for filament wound vessels
   12.3 Hydrostatic pressure test
   12.4 Test report
Annex A (normative) - Fabrication of flat filament wound
                         test specimens
Annex B (informative) - Laminate Theory
Annex C (normative) - Extrapolation method for long term
                         behaviour
Annex D (informative) - Calculation example
Annex ZA (informative) - Relationship between this European
                         Standard and the Essential
                         Requirements of EU Directive 97/23/EC
Bibliography

Defines the requirements for the design including raw materials, calculation, manufacturing including composite materials, and testing of seamless Glass Reinforced Plastic (GRP) pressure vessels with protective layer, using only multi-directional filament winding, made in a factory and for use above ground and for storage and processing of fluids.