NBN EN 60384-24 : 2007

1 General
  1.1 Scope
  1.2 Object
  1.3 Normative references
  1.4 Information to be given in a detail specification
  1.5 Terms and definitions
  1.6 Marking
2 Preferred rating and characteristics
  2.1 Preferred characteristics
  2.2 Preferred values of ratings
3 Quality assessment procedures
  3.1 Primary stage of manufacture
  3.2 Structurally similar components
  3.3 Declaration conformity (basic requirements)
  3.4 Test schedule and requirement for initial assessment
       (mandatory and optional tests)
  3.5 Quality conformance inspection
4 Test and measurement procedures
  4.1 Preliminary drying
  4.2 Measuring conditions
  4.3 Mounting
  4.4 Visual examination and check of dimensions
  4.5 Electrical tests
  4.6 Resistance to soldering heat
  4.7 Solderability
  4.8 Shear test
  4.9 Substrate bending test
  4.10 Rapid change of temperature
  4.11 Climatic sequence
  4.12 Damp heat, steady state
  4.13 Characteristics at high and low temperature
  4.14 Surge
  4.15 Endurance
  4.16 Component solvent resistance (if applicable)
  4.17 Solvent resistance of marking (if applicable)
  4.18 High surge current (if applicable)
  4.19 Storage at high temperature
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

Applies to tantalum electrolytic capacitors with conductive polymer solid electrolyte. These capacitors are primarily intended to be mounted direct on to substrates for hybrid circuits or to printed boards.