NBN EN 60384-3 : 2007

1 General
  1.1 Scope
  1.2 Object
  1.3 Normative references
  1.4 Information to be given in a detail specification
  1.5 Terms and definitions
  1.6 Marking
2 Preferred ratings and characteristics
  2.1 Preferred characteristics
  2.2 Preferred values of ratings
3 Quality assessment procedures
  3.1 Primary stage of manufacture
  3.2 Structurally similar components
  3.3 Certified records of released lots
  3.4 Qualification approval
  3.5 Quality conformance inspection
4 Test and measurement procedures
  4.1 Preliminary drying
  4.2 Measuring conditions
  4.3 Mounting
  4.4 Visual examination and check of dimensions
  4.5 Electrical tests
  4.6 Resistance to soldering heat
  4.7 Solderability
  4.8 Shear test
  4.9 Substrate bending test
  4.10 Rapid change of temperature
  4.11 Climatic sequence (applicable to Style 1
       capacitors only)
  4.12 Damp heat, steady state (applicable to Style 1
       capacitors only)
  4.13 Characteristics at high and low temperature
  4.14 Surge
  4.15 Endurance
  4.16 Reverse voltage (if required by the detail
       specification)
  4.17 Component solvent resistance (if required by
       the detail specification)
  4.18 Solvent resistance of the marking (if required
       by the detail specification)
  4.19 High surge current (if required by the detail
       specification)
Annex A (normative) Test plans for assessment level EZ
Annex B (normative) Test schedule for assessment level EZ
Annex ZA (normative) Normative references to international
                     publications with their corresponding
                     European publications

Applies to surface mount tantalum solid electrolyte capacitors. These capacitors are primarily intended to be mounted directly onto substrates for hybrid circuits or onto printed boards.