NBN EN 60384-4 : 2007

1 General
  1.1 Scope
  1.2 Object
  1.3 Normative references
  1.4 Information to be given in a detail specification
  1.5 Terms and definitions
  1.6 Marking
2 Preferred ratings and characteristics
  2.1 Preferred characteristics
  2.2 Preferred values of ratings
3 Quality assessment procedures
  3.1 Primary stage of manufacture
  3.2 Structurally similar components
  3.3 Certified records of released lots
  3.4 Qualification approval procedures
  3.5 Quality conformance inspection
4 Test and measurement procedures
  4.1 Pre-conditioning (for non-solid electrolyte
       capacitors only)
  4.2 Visual examination and check of dimensions
  4.3 Electrical tests
  4.4 Robustness of terminations
  4.5 Resistance to soldering heat
  4.6 Solderability
  4.7 Rapid change of temperature
  4.8 Vibration
  4.9 Bump
  4.10 Shock
  4.11 Climatic sequence
  4.12 Damp heat, steady state
  4.13 Endurance
  4.14 Surge
  4.15 Reverse voltage (if required by the detail
       specification)
  4.16 Pressure relief (if required by the detail
       specification)
  4.17 Storage at high temperature
  4.18 Storage at low temperature (for non-solid
       electrolyte capacitors only)
  4.19 Characteristics at high and low temperature
  4.20 Charge and discharge (if required by the
       detail specification)
  4.21 High surge current (for solid electrolyte capacitors
       only and if required by the detail specification)
  4.22 Voltage transient overload
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

Applies to aluminium electrolytic capacitors with solid (MnO[2]) and non-solid electrolyte primarily intended for d.c. applications for use in electronic equipment.