NBN EN 60464-2 : 2002 AMD 1 2006

INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General notes on methods of test
5 Methods of test for undreid and/or uncured varnishes
   5.1 Flashpoint
   5.2 Density
   5.3 Viscosity
   5.4 Content of non-volatile matter
   5.5 Dilution ability
   5.6 Stability of varnish in an open vessel
   5.7 Drying and/or curing in thick layer
   5.8 Effect of varnish on enamelled winding wires
6 Methods of test for dried and/or cured varnishes
   6.1 Test specimen
   6.2 Mechanical properties
   6.3 Thermal properties
   6.4 Chemical properties
   6.5 Electrical properties
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Figure 1 - Test set-up for volume resistivity
Figure 2 - Example of electrode arrangement
Table 1 - Condition of the top side
Table 2 - Condition of the bottom side
Table 3 - Condition of the interior

Describes methods of test to be used for testing varnishes used for electrical insulation.