NBN EN 61347-2-12 : 2006 AMD 1 2011

INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Terminals
9 Provisions for earthing
10 Protection against accidental contact with live parts
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Protection of associated components
16 Ignition voltage
17 Abnormal conditions
18 Construction
19 Creepage distances and clearances
20 Screws, current-carrying parts and connections
21 Resistance to heat, fire and tracking
22 Resistance to corrosion
Annex A (normative) Test to establish whether a conductive
        part is a live part which may cause an electric shock
Annex B (normative) Particular requirements for thermally
        protected lamp controlgear
Annex C (normative) Particular requirements for electronic
        lamp controlgear with means of protection against
        overheating
Annex D (normative) Information for carrying out the heating
        tests of thermally protected lamp controlgear
Annex E (normative) The use of constants S other than 4 500
        in t[w] tests
Annex F (normative) Draught-proof enclosure
Annex G (normative) Explanation of the derivation of the values
        of pulse voltages
Annex H (normative) Tests
Annex I (normative) Precautions to be observed when measuring
        with spherical spark gaps
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications
Bibliography

Describes particular general and safety requirements for d.c. or a.c. supplied electronic ballasts. The supply comprises a.c. voltages up to 1000 V at 50 Hz/60 Hz. The type of ballast is an convertor that may contain igniting and stabilising elements for operation of a discharge lamp at d.c. or at a frequency that can deviate from the supply frequency.