NBN EN ISO 14692-3 : 2003 COR 2006

Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Layout requirements
   5.1 General
   5.2 Space requirements
   5.3 System supports
   5.4 Isolation and access for cleaning
   5.5 Vulnerability
   5.6 Joint selection
   5.7 Fire and blast
   5.8 Control of electrostatic discharge
   5.9 Galvanic corrosion
6 Hydraulic design
   6.1 General
   6.2 Flow characteristics
   6.3 General velocity limitations
   6.4 Erosion
   6.5 Water hammer
   6.6 Cyclic conditions
7 Structural design
   7.1 General
   7.2 Manufacturer's pressure rating
   7.3 Qualified pressure
   7.4 Factored qualified pressure
   7.5 System design pressure
   7.6 Loading requirements
   7.7 Allowable displacements
   7.8 Qualified stress
   7.9 Factored stress
   7.10 Limits of calculated stresses due to loading
   7.11 Determination of failure envelope
8 Stress analysis
   8.1 Analysis methods
   8.2 Analysis requirements
   8.3 External pressure/vacuum
   8.4 Thermal loading
   8.5 Stresses due to internal pressure
   8.6 Stresses due to pipe support
   8.7 Axial compressive load (buckling)
9 Fire performance
   9.1 General
   9.2 Fire endurance
   9.3 Fire reaction
   9.4 Fire-protective coatings
10 Static electricity
   10.1 General
   10.2 Classification code for the control of electrostatic
         charge accumulation
   10.3 Mitigation options
   10.4 Design and documentation requirements
   10.5 Pipes that contain a fluid with an electrical
         conductivity more than 10000 pS/m
   10.6 Pipes that contain a fluid with an electrical
         conductivity less than 10000 pS/m
   10.7 Pipes exposed to weak/moderate external
         electrostatic-generation mechanisms
   10.8 Pipes exposed to strong external electrostatic
         generation mechanisms
   10.9 Continuity of electrical path within piping system
   10.10 Lightning strike
11 Installer and operator documentation
Annex A (informative) Guidance for design of GRP piping system
        layout
Annex B (informative) Description and guidance on selection
        of jointing designs
Annex C (informative) Guidance on material properties and
        stress/strain analysis
Annex D (normative) Guidance on flexibility analysis
Annex E (normative) Calculation of support stresses for
        large-diameter liquid-filled pipe
Annex F (informative) Guidance on quantifying fire
        performance properties
Annex G (informative) Static electricity
Annex H (informative) Inspection strategy
Bibliography

Defines guidelines for the design of GRP piping systems. The requirements and recommendations apply to layout dimensions, hydraulic design, structural design, detailing, fire endurance, spread of fire and emissions and control of electrostatic discharge.