NEMA TC 10 : 1993
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
PVC PLASTIC COMMUNICATIONS DUCT AND FITTINGS FOR UNDERGROUND INSTALLATION
08-05-1996
12-01-2013
Foreword
Scope
Section 1
Section 1 Referenced standards and definitions
Referenced standards
Definitions and abbreviations
Section 2 General requirements
Materials
Nominal sizes
Dimensions
Section 3 Performance requirements
Qualification tests for joints
Quality control tests
Section 4 Test methods
Conditioning, Test conditions and sampling
Dimensions
Duct stiffness
Leakage of joints
Duct impact resistance
Section 5 Markings
Appendix A Socket bottom and socket entrance go no-go
for belled end dimensions shown in table 2-2
Socket bottom go no-go gage
Socket entrance go no-go gage
Appendix B Suggested joining methods
Solvent cement joining of PVC conduit materials
Materials
Joint preparations
Application of cement
Assembly of joint
Appearance of joint
Application of cement and assembly for severe service
conditions where maximum strength and leaktight joints
are essential
Joint preparation
Application of cement
Assembly of joint
Appearance of joint
Set time
Specifies two types of plastic communications duct and fittings with nominal size 3 or 4 inches for underground installation of communication wire and cable.
| DocumentType |
Standard
|
| PublisherName |
National Electrical Manufacturers Association
|
| Status |
Withdrawn
|
| ASTM D 618 : 2013 : REDLINE | Standard Practice for Conditioning Plastics for Testing |
| ASTM D 2444 : 1999 | Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight) |
| ASTM D 2122 : 2016 : REDLINE | Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings |
| NFPA 325M : 1991 | FIRE HAZARD PROPERTIES OF FLAMMABLE LIQUIDS, GASES, AND VOLATILE SOLIDS |
| ASTM D 4396 : 2015 | Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) and Chlorinated Poly(Vinyl Chloride) (CPVC) Compounds for Plastic Pipe and Fittings Used in Nonpressure Applications |
| ASTM D 1784 : 2011 : REDLINE | Standard Specification for Rigid Poly(Vinyl Chloride) (PVC) Compounds and Chlorinated Poly(Vinyl Chloride) (CPVC) Compounds |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.