NEN EN 10142 : 2000

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification and designation
      4.1 Classification
      4.2 Designation
5 Information to be supplied by the purchaser
      5.1 Mandatory information
      5.2 Options
6 Manufacturing process
7 Requirements
      7.1 Mechanical properties
      7.2 Coatings
      7.3 Coating finish
      7.4 Surface quality
      7.5 Surface treatment (surface protection)
      7.6 Freedom from coil breaks
      7.7 Stretcher strains
      7.8 Coating mass
      7.9 Adhesion of coating
      7.10 Surface condition
      7.11 Tolerances on dimensions and shape
      7.12 Suitability for further processing
8 Testing
      8.1 General
      8.2 Test units
      8.3 Number of tests
      8.4 Sampling
      8.5 Test methods
      8.6 Retests
      8.7 Inspection documents
9 Marking
10 Packing
11 Storage and transportation
12 Disputes
Annex A (normative) Reference method for determination of
                    the zinc coating mass
Annex B (informative) List of corresponding former
                      designations
Bibliography

Defines requirements for continuously hot-dip zinc coated flat products in thicknesses up to and including 3,0mm - unless otherwise agreed at the time of ordering. Applies to strip of all widths and to sheets and lengths cut from it. Not applicable to continuously hot-dip zinc coated structural steel strip and sheet; electrolytically zinc coated cold rolled steel flat/continuously organic coated steel flat products, or continuously hot-dip coated strip and sheet of steels with higher yield strength for cold forming. The thickness is the final thickness of the delivered product after zinc coating.