NEN EN 122150 : 1996

Foreword
Preface
Introduction
Section 1. Scope
Section 2. Mating face and gauge information
2.1 Dimensions
2.2 Drawings
2.3 Gauges for male centre contacts
Section 3. Properties
3.1 Ratings and characteristics
Section 4. Test conditions and severities
4.1 Measurement and recovery conditions
4.2 Visual examination
4.3 Dimensions
4.4 Electrical tests and measurements
4.5 Mechanical tests and measurements
4.6 Environmental tests and measurements
4.7 Endurance tests
Section 5. Quality assessment procedures
5.1 Test schedules and inspection requirements

Gives information and rules for preparation of detail specifications (DS) for general purpose connectors Series EIA Flange, also prescribes mating-face dimensions for general purpose connectors, gauging information and mandatory tests applicable to all DS relating to Series EIA FLANGE connectors. Also shows recommended performance characteristics for consideration when writing a DS, covering test schedules and inspection requirements for Assessment Levels H, M and U.