NEN EN 13035-1 : 2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protective measures
  5.1 General
  5.2 Mechanical strength
  5.3 Angle of lean
  5.4 Retention of glass
  5.5 Cladding materials
  5.6 Tow bars
  5.7 Stability of storage equipment
  5.8 Vacuum-lifting device for use inside the factory
  5.9 Other hazards
6 Verification of safety requirements and/or protective measures
7 Information for use
  7.1 General
  7.2 Signals and warning devices
  7.3 Accompanying documents
  7.4 Marking
Annex A (informative) Overview over equipment for glass storing,
                      handling and transporting
Annex B (informative) Terminology
      B.1 Referring to glass
          B.1.1 Glass height 'H'
          B.1.2 Glass length 'L'
          B.1.3 Product
          B.1.4 Cullet
          B.1.5 Flat glass
          B.1.6 Substance
          B.1.7 Vent
      B.2 Referring to storage equipment
          B.2.1 Attitude of glass in any type of equipment
          B.2.2 Type of equipment
Annex C (informative) Minimum clearances for interfacing equipment
      C.1 Vertical supporting bearers and the grab
      C.2 Horizontal base bearers and the grab
      C.3 Horizontal supporting bearers and the grab
      C.4 Interfacing structural (non supporting) equipment and
          handling device fingers
      C.5 Beam-strap sling and over-the-top grab
Annex ZA (informative) Relationship between this European Standard
                       and the Essential Requirements of EU Directive
                       98/37/EC
Annex ZB (informative) Relationship between this European Standard
                       and the Essential Requirements of EU Directive
                       2006/42/EC
Bibliography

Specifies the requirements for safety for the design and installation of equipment intended for the storage, handling and transportation of flat glass inside the factory as described in Clause 3.